STPM11ATR STMicroelectronics, STPM11ATR Datasheet - Page 17

• Manufacturer Part Number: STPM11ATR
• Description: IC ENERGY METER 1 PHASE 20TSSOP
• Manufacturer: STMicroelectronics

Specifications of STPM11ATR

• Input Impedance: 100 KOhm
• Measurement Error: 0.1%
• Voltage - I/o High: 1.5V
• Voltage - I/o Low: 0.8V
• Current - Supply: 4.7mA
• Voltage - Supply: 3 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 20-TSSOP
• Meter Type: Single Phase
• Output Voltage: +/- 0.4 V
• Output Current: 150 mA
• Input Voltage: 3 V to 5.5 V
• Operating Temperature Range: - 40 C to + 85 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-5984-2

STPM11, STPM12, STPM13, STPM14
Figure 15. First order ∑ Δ A/D converter
7.4
A ∑ Δ modulator converts the input signal into a continuous serial stream of 1s and 0s at a
rate determined by the sampling clock. In the STPM1X, the sampling clock is equal to
f
output is subtracted from the input signal. If the loop gain is high enough, the average value
of the DAC output (and therefore the bit stream) can approach that of the input signal level.
When a large number of samples are averaged, a very precise value of the analog signal is
obtained. This averaging is carried out in the DSP section which implements decimation,
integration and DC offset cancellation of the supplied ∑ Δ signals. The gain of the
decimation filters is 1.004 for the voltage channel and 0.502 for the current channel. The
resulting signal has a resolution of 11bits for voltage channel and 16 bits for current channel.
Period and line voltage measurement
The period module measures the period of base frequency of voltage channel and checks if
the voltage signal frequency is in the band from f
produced at every positive peak of the line voltage. If the counted number of pulses between
two trailing edges of this signal is higher than the f
counting is stopped (internal signal is not available), it means that the base frequency is
lower than f
If the counted number of pulses within one line period is higher than the f
pulses, the base frequency exceeds the limit. In this case, such error must be repeated
three times in a row, in order to set the error flag BFR.
The BFR flag is also set if the value of the RMS voltage drops below a certain value (BFR-
on) and it is cleared when the RMS voltage goes above BFR-off threshold. The table below
shows the equivalent RMS voltage on the V
channel calibrator.
The BFR flag is also set if the RMS voltage across V
calculated with the following formula:
CLK
/4. The 1-bit DAC in the feedback loop is driven by the serial data stream. The DAC
Input analog signal
CLK
/2
17
Hz and an internal error flag BFR (base frequency range) is set.
+
Σ
-
Doc ID 13167 Rev 7
Integrator
∫
DAC
f
IP
CLK
/V
/4
IN
CLK
pins according to the value of the voltage
CLK
/2
IP
/2
17
-V
17
IN
Output digital signal
to f
Hz equivalent pulses or if the
drops below a threshold value
CLK
/2
15
. An internal signal is
Theory of operation
CLK
/2
15
equivalent
17/46