LP3950SL/NOPB National Semiconductor, LP3950SL/NOPB Datasheet - Page 5

• Manufacturer Part Number: LP3950SL/NOPB
• Description: IC LED DRVR WHITE BCKLGT 32-TSCP
• Manufacturer: National Semiconductor
• Series: PowerWise®r
• Type: Backlight, White LED (I²C Interface)r

Specifications of LP3950SL/NOPB

• Topology: PWM, Step-Up (Boost)
• Number Of Outputs: 6
• Internal Driver: Yes
• Type - Primary: Flash/Torch, LED Blinker, Light Management Unit (LMU)
• Type - Secondary: RGB, White LED
• Frequency: 2MHz
• Voltage - Supply: 2.7 V ~ 2.9 V
• Voltage - Output: 5V
• Mounting Type: Surface Mount
• Package / Case: 32-Laminate TCSP
• Operating Temperature: -40°C ~ 85°C
• Internal Switch(s): Yes
• Efficiency: 90%
• Led Driver Application: Mobile Phone Display Lighting, General LED Lighting
• No. Of Outputs: 6
• Output Current: 300mA
• Output Voltage: 5.3V
• Input Voltage: 3V To 7.2V
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Output / Channel: -
• Other names: LP3950SL/CSP1; LP3950SLTR

Electrical Characteristics
(Notes 2, 11) (Continued)
Note 9: In applications where high power dissipation and/or poor package thermal resistance is present, the maximum ambient temperature may have to be
derated. Maximum ambient temperature (T
) is dependent on the maximum operating junction temperature (T
= 125˚C), the maximum power
A-MAX
J-MAX-OP
dissipation of the device in the application (P
), and the junction-to ambient thermal resistance of the part/package in the application (θ
), as given by the
D-MAX
JA
following equation: T
= T
− (θ
x P
).
A-MAX
J-MAX-OP
JA
D-MAX
Note 10: Junction-to-ambient thermal resistance is highly application and board-layout dependent. In applications where high maximum power dissipation exists,
special care must be paid to thermal dissipation issues in board design.
Note 11: Min and Max limits are guaranteed by design, test, or statistical analysis. Typical numbers are not guaranteed, but do represent the most likely norm.
Note 12: Low-ESR Surface-Mount Ceramic Capacitors are used in setting electrical characteristics.
Note 13: Audio block inactive.
Note 14: In single-ended and in differential mode one audio buffer only is active and I
will be reduced by 90 µA (typ).
VDDA
Note 15: V
pin (Bandgap reference output) is for internal use only. A capacitor should always be placed between V
and GND1.
REF
REF
5
www.national.com