BD6517F-E2 Rohm Semiconductor, BD6517F-E2 Datasheet - Page 18

• Manufacturer Part Number: BD6517F-E2
• Description: IC SWITCH HIGH SIDE 2CH SOP-8
• Manufacturer: Rohm Semiconductor
• Type: High Sider

Specifications of BD6517F-E2

• Input Type: Non-Inverting
• Number Of Outputs: 2
• On-state Resistance: 110 mOhm
• Current - Output / Channel: 500mA
• Current - Peak Output: 1.65A
• Voltage - Supply: 3 V ~ 5.5 V
• Operating Temperature: -25°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOP
• Power Load Switch Type: High Side
• Input Voltage: 5.5V
• On Resistance Rds(on): 0.11ohm
• On / Enable Input Polarity: Active Low
• Power Dissipation Pd: 560mW
• No. Of Outputs: 2
• Current Limit: 1.65A
• Supply Voltage (min): 3 V
• Supply Voltage (max): 5.5 V
• Supply Current (typ): 100 uA
• Operating Temperature Range: - 25 C to + 85 C
• Mounting Style: SMD/SMT
• On State Resistance: 0.11ohm
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: BD6517F-E2TR

Application information
Thermal derating characteristic
© 2009 ROHM Co., Ltd. All rights reserved.
BD6512F,BD6513F,BD6516F,BD6517F,BD2042AFJ,BD2052AFJ
www.rohm.com
When excessive current flows owing to output shortcircuit or so, ringing occurs by inductance of power source line to IC, and
may cause bad influences upon IC operations. In order to avoid this case, connect a bypass capacitor by VDD pin and GND
pin of IC. 1uF or higher is recommended.
Pull up flag output by resistance 10kΩ ~ 100kΩ.
Set up value which satisfies the application as C
This system connection diagram doesn’t guarantee operating as the application.
The external circuit constant and so on is changed and it uses, in which there are adequate margins by taking into account
external parts or dispersion of IC including not only static characteristics but also transient characteristics.
In BD6512F/BD6513F, there are cases where over current detection error flag is output to inrush current at switch on or at
insertion of active line of peripheral devices. In the case of erroneous detection inBD6512F/BD6513F, use RC filter shown in
Fig. 90 for FLAG output.
(SOP8, SOP-J8)
600
500
400
300
200
100
0
0
USB Controller
25
Fig.92 Power dissipation curve
OC
Fig.90 FLAG output RC filter
AMBIENT TEMPERATURE: Ta [ ℃ ]
L
50
VDD
and Ferrite Beads.
18/20
75
CTRLA
FLAGA
FLAGB
CTRLB
100
BD6512F/13F
OUTB
OUTA
GND
VDD
125
150
2009.05 - Rev.A
Technical Note