L6564D STMicroelectronics, L6564D Datasheet - Page 25

• Manufacturer Part Number: L6564D
• Description: IC PFC CTRLR TRANSITION 10SSOP
• Manufacturer: STMicroelectronics

Specifications of L6564D

• Mode: Discontinuous (Transition)
• Frequency - Switching: 1MHz
• Current - Startup: 90µA
• Voltage - Supply: 10.3 V ~ 22.5 V
• Operating Temperature: -25°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 10-SSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: L6564; L6564

L6564
6.6
Power management/housekeeping functions
A communication line with the control IC of the cascaded dc-dc converter can be
established via the disable function included in the PFC_OK pin (see “Feedback failure
protection” section for more details). Typically this line is used to allow the PWM controller of
the cascaded dc-dc converter to shut down the L6564 in case of light load and to minimize
the no-load input consumption. Should the residual consumption of the chip be an issue, it is
also possible to cut down the supply voltage. Interface circuits like those are shown in figure
32. Needless to say, this operation assumes that the cascaded dc-dc converter stage works
as the master and the PFC stage as the slave or, in other words, that the dc-dc stage starts
first, it powers both controllers and enables/disables the operation of the PFC stage.
Figure 33. Interface circuits that let dc-dc converter's controller IC disable the L6564
Another function available is the brownout protection which is basically a not-latched
shutdown function that is activated when a condition of mains under voltage is detected.
This condition may cause overheating of the primary power section due to an excess of
RMS current. Brownout can also cause the PFC pre-regulator to work open loop and this
could be dangerous to the PFC stage itself and the downstream converter, should the input
voltage return abruptly to its rated value. Another problem is the spurious restarts that may
occur during converter power down and that cause the output voltage of the converter not to
decay to zero monotonically. For these reasons it is usually preferable to shutdown the unit
in case of brownout. Brownout threshold is internally fixed at 0.8V and is sensed on pin VFF
(5) during the voltage falling and 80 mV threshold hysteresis prevents from rebounding at
input voltage turn off. In
mentioned working conditions that cause the device to stop operating.
Table 5
Doc ID 16202 Rev 2
it is possible to find a summary of all of the above
Application information
25/33