ISL6443AIRZ-TK Intersil, ISL6443AIRZ-TK Datasheet - Page 17
![IC CTRLR SGL/STP DWN PWM 28-QFN](/photos/7/54/75412/isl6540acrz-t_sml.jpg)
ISL6443AIRZ-TK
Manufacturer Part Number
ISL6443AIRZ-TK
Description
IC CTRLR SGL/STP DWN PWM 28-QFN
Manufacturer
Intersil
Datasheet
1.ISL6443AIRZ.pdf
(19 pages)
Specifications of ISL6443AIRZ-TK
Applications
Power Supplies
Current - Supply
2mA
Voltage - Supply
5.6 V ~ 24 V
Operating Temperature
-40°C ~ 85°C
Mounting Type
Surface Mount
Package / Case
28-QFN
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Input Capacitor Selection
The important parameters for the bulk input capacitor(s) are
the voltage rating and the RMS current rating. For reliable
operation, select bulk input capacitors with voltage and
current ratings above the maximum input voltage and largest
RMS current required by the circuit. The capacitor voltage
rating should be at least 1.25x greater than the maximum
input voltage and 1.5x is a conservative guideline. The AC
RMS Input current varies with the load. The total RMS
current supplied by the input capacitance is:
where,
DC is duty cycle of the respective PWM.
Depending on the specifics of the input power and its
impedance, most (or all) of this current is supplied by the
input capacitor(s). Figure 20 shows the advantage of having
the PWM converters operating out-of-phase. If the
converters were operating in-phase, the combined RMS
current would be the algebraic sum, which is a much larger
value as shown. The combined out-of-phase current is the
square root of the sum of the square of the individual
reflected currents and is significantly less than the combined
in-phase current.
I
I
RMS
RMSx
=
=
I
2
RMS1
DC DC
–
+
I
2
RMS2
2
⋅
I
O
17
(EQ. 16)
(EQ. 17)
ISL6443A
Use a mix of input bypass capacitors to control the voltage
ripple across the MOSFETs. Use ceramic capacitors for the
high frequency decoupling and bulk capacitors to supply the
RMS current. Small ceramic capacitors can be placed very
close to the upper MOSFET to suppress the voltage induced
in the parasitic circuit impedances.
For board designs that allow through-hole components, the
Sanyo OS-CON® series offer low ESR and good
temperature performance. For surface mount designs, solid
tantalum capacitors can be used, but caution must be
exercised with regard to the capacitor surge current rating.
These capacitors must be capable of handling the
surge-current at power-up. The TPS series available from
AVX is surge-current tested.
5.0
4.5
4.0
3.5
3.0
2.5
2.0
1.5
1.0
0.5
0
0
FIGURE 20. INPUT RMS CURRENT vs LOAD
OUT-OF-PHASE
1
3.3V AND 5V LOAD CURRENT
IN-PHASE
2
3
3.3V
4
June 2, 2008
FN6600.2
5V
5