NHD-240128WG-AFTI-VZ#C5 Newhaven Display, NHD-240128WG-AFTI-VZ#C5 Datasheet - Page 24

• Manufacturer Part Number: NHD-240128WG-AFTI-VZ#C5
• Description: LCD MOD GRAPHIC 240X128 TRANSM
• Manufacturer: Newhaven Display

Specifications of NHD-240128WG-AFTI-VZ#C5

• Display Type: FSTN - Film Super-Twisted Nematic
• Display Mode: Transmissive
• Viewing Area: 129.00mm L x 75.00mm W
• Backlight: CCFL - White
• Dot Size: 0.47mm W x 0.47mm H
• Dot Pitch: 0.50mm x 0.50mm
• Dot Pixels: 240 x 128
• Interface: Parallel
• Pixel Density: 240 x 128
• Fluid Type: FSTN Negative
• Module Size (w X H X T): 170 mm x 103.5 mm x 14 mm
• Backlighting: LED White
• Operating Temperature Range: - 20 C to + 70 C
• Product: Graphic LCD Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

a)Auto Read mode
When cursor display is ON, this command selects the cursor pattern in the range 1 line to 8 lines.
The cursor address is defined by the Cursor Pointer Set command.
Data Auto Read/Write
The command is convenient for sending a full screen of data from the external display RAM. After
setting Auto mode, a Data Write (or Read) command is need not be sent between each datum. A Data
Auto Write (or Read) command must be sent after a Set Address Pointer command. After this
command, the address pointer is automatically incremented by 1 after each datum. In Auto mode, the
T6963C cannot accept any other commands.
The Auto Reset command must be sent to the T69963C after all data has been sent, to clear Auto mode.
(Note) A Status check for Auto mode
10100100
10100101
10100110
10100111
10110000
10110001
10110010
CODE
(STA2, STA3 should be checked between sending of each datum. Auto Reset should be
performed after checking STA3=1 (STA2=1.) Refer to the following flowchart.
HEX.
B0H
B1H
B2H
5-line cursor
6-line cursor
7-line cursor
8-line cursor
Set Data Auto Write
Set Data Auto Read
Auto Reset
FUNCTION
b)Auto Write mode
OPERAND