GS-R12FS0001.9 STMicroelectronics, GS-R12FS0001.9 Datasheet - Page 6
![CONVERTR MODULE DC-DC 1.9A 12SMD](/photos/8/70/87057/gs-r12fs0001_9_sml.jpg)
GS-R12FS0001.9
Manufacturer Part Number
GS-R12FS0001.9
Description
CONVERTR MODULE DC-DC 1.9A 12SMD
Manufacturer
STMicroelectronics
Series
GS-R12FPr
Type
Point of Load (POL) Non-Isolatedr
Specifications of GS-R12FS0001.9
Output
1.235 ~ 5.5V
Number Of Outputs
1
Power (watts)
10W
Mounting Type
Surface Mount
Voltage - Input
4.5 ~ 15V
Package / Case
10-SMD Module
1st Output
1.235 ~ 5.5 VDC @ 1.9A
Size / Dimension
1.52" L x 0.18" W x 0.50" H (38.7mm x 4.5mm x 12.7mm)
Power (watts) - Rated
10.5W
Operating Temperature
-25°C ~ 85°C
Efficiency
83%
Screening Level
Commercial
Operating Temperature Min Deg. C
-25C
Operating Temperature Max Deg. C
85C
Product Height (mm)
12.7mm
Mounting Style
Surface Mount
Pin Count
10
Output Voltage
1.235 V to 5.5 V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
3rd Output
-
2nd Output
-
Lead Free Status / Rohs Status
Compliant
Other names
497-8252
Application information
4
4.1
4.2
4.3
4.4
4.5
6/13
Input voltage
Reference voltage
Inhibit function
Current limitation
Application information
The recommended maximum operating DC Input Voltage is 15 V including ripple voltage.
No capacitor is required for stability.
The inhibit feature allows to put the device in stand-by mode.
With INH pin 1 is higher than 2.2 V the device is disabled and the current consumption is
reduced to less than 100 µA for V
With INH pin lower than 0.8 V, the device is enabled.
If the INH pin is left floating, an internal pull up ensures that the voltage at the pin reaches
the inhibit threshold and the device is disabled.
The pin can be pulled to V
Multiple units synchronization
Using more than one unit on the same circuit, it is possible to synchronize the switching
frequency, connecting all pin 12 together (see
The unit with higher frequency becomes the master.
The device has two current limit protections, pulse by pulse and frequency fold back.
The current is sensed through a resistor and if it reaches the threshold, the on time is
reduced and consequently the output voltage, too.
Since the minimum switch ON time (necessary to avoid false overcurrent signal) is not
enough to obtain a sufficiently low duty cycle at 250 Hz, the output current could increase
again, in strong overcurrent or short circuit conditions.
For this reason the switching frequency is also reduced to keep the inductor current within
its maximum threshold limit.
The frequency depends on the feedback voltage.
As the feedback voltage decreases (due to the reduced duty cycle), the switching frequency
decrease too.
i
to disable the device.
i
= 15 V.
Figure
5).
GS-R12F