P0302 Terasic Technologies Inc, P0302 Datasheet - Page 11

• Manufacturer Part Number: P0302
• Description: USB BLASTER CABLE
• Manufacturer: Terasic Technologies Inc

Specifications of P0302

• Accessory Type: Download Cable
• For Use With/related Products: Altera Devices
• Lead Free Status / RoHS Status: Not applicable / Not applicable

Setting Up the USB-Blaster Download Cable
Figure 1–1. The USB-Blaster Download Cable
Software Setup
Altera Corporation
May 2007
10-pin Female Connector
(connects to target printed
circuit board 10-pin male
header)
4.
1
This section describes the following:
■
■
Installing the USB-Blaster Driver on Windows 2000 and
Windows XP Systems
This section describes how to install the USB-Blaster driver on Windows
2000 and Windows XP systems.
Before you begin the installation, verify the USB-Blaster driver is located
in your directory: \<Quartus II system directory>\drivers\usb-blaster
1
USB-Blaster Download Cable User Guide
Reconnect the power cable to reapply power to the circuit board.
Installing the USB-Blaster driver
Setting up the USB-Blaster hardware in the Quartus II software
The Found New Hardware wizard may open and prompt you
to install a new hardware driver. Close the wizard and install the
hardware driver using the instructions provided in
the USB-Blaster Driver on Windows 2000 and Windows XP
Systems”
If the driver is not in your directory, download the USB-Blaster
driver from the Altera web site:
www.altera.com/support/software/drivers
below.
“Installing
1–3