P0302 Terasic Technologies Inc, P0302 Datasheet - Page 9

• Manufacturer Part Number: P0302
• Description: USB BLASTER CABLE
• Manufacturer: Terasic Technologies Inc

Specifications of P0302

• Accessory Type: Download Cable
• For Use With/related Products: Altera Devices
• Lead Free Status / RoHS Status: Not applicable / Not applicable

Introduction
Altera Corporation
May 2007
The USB-Blaster™ download cable interfaces a USB port on a host
computer to an Altera
cable sends configuration data from the PC to a standard 10-pin header
connected to the FPGA. You can use the USB-Blaster cable to iteratively
download configuration data to a system during prototyping or to
program data into the system during production.
Device Support
The USB-Blaster download cable allows you to program and configure
Altera devices. Specifically, you can do the following:
■
■
■
■
■
In addition, the USB-Blaster download cable supports target systems
using 5.0 V TTL, 3.3 V LVTTL/LVCMOS, and single-ended I/O
standards from 1.5 V to 3.3 V.
Power Requirements
The USB-Blaster download cable requires the following power sources:
■
■
Download configuration data to FPGA devices:
●
●
●
●
●
●
●
Download configuration data to User Flash Memory (UFM) devices:
●
Download configuration data to EEPROM-based devices:
●
Perform in-system programming of advanced configuration devices:
●
Perform in-system programming of serial configuration devices:
●
5.0 V from the USB cable
Between 1.5 V and 5.0 V from the target circuit board
Stratix
Cyclone
APEX
ACEX
Mercury
FLEX
Excalibur
MAX
MAX 3000 and MAX 7000 family of devices
EPC2, EPC4, EPC8, EPC16, and EPC1441 devices
EPCS1, EPCS4, EPCS16, and EPCS64 devices
®
™
™
®
®
II family of devices
USB-Blaster Download Cable
10K, FLEX 10KE, and FLEX 10KA family of devices
1K devices
II, Stratix II GX, Stratix GX, and Stratix family of devices
™
II and APEX 20K family of devices
™
™
II and Cyclone family of devices
devices
devices
®
Chapter 1. Setting Up the
FPGA mounted on a printed circuit board. The
Preliminary
1–1