ST62GP-DBE STMicroelectronics, ST62GP-DBE Datasheet - Page 39

• Manufacturer Part Number: ST62GP-DBE
• Description: DEDICATED BOARD FOR ST EMULATORS
• Manufacturer: STMicroelectronics

Specifications of ST62GP-DBE

• Accessory Type: Emulator Adaptor
• For Use With/related Products: ST62GP-EMU2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST62GP-EMU2 Emulator User Manual
5
5.1
Note:
5.2
5.3
Note:
EMULATOR FEATURES
Clock source
The clock source can be configured by software on the dedication board and using
jumpers W1 and W2 on the probe board. The clock source can also be configured
from an oscillator on the:
•
•
A crystal or ceramic resonator on the application board must not be used as a clock source
for the emulator.
Dedication board oscillator
The dedication board oscillator is selectable with the software. Possible selections
are:
•
•
•
•
•
•
•
•
•
Probe board oscillator
The probe board has locations for soldering a crystal or a ceramic resonator which
can be used as the clock source of the emulated MCU. To select this,
1
2
3
When you install an oscillator on the probe board, you may have to change the capacitors
(refer to
Probe board, or
TTL signal input to the OSCIN pin of the probe.
500kHz
1MHz
2MHz
3MHz
4MHz
5MHz
6MHz
7MHz
8MHz
Select EXTERNAL in the menu Command -> Micro_Configuration ->
Frequency.
Remove the jumper between pins 1-2 of W2 on the probe board.
Install a jumper between pins 1-2 of W1 on the probe board.
Changing the oscillator on the probe board
on page 40).
5 - Emulator Features
39/57