AS5040 PB austriamicrosystems, AS5040 PB Datasheet - Page 24

• Manufacturer Part Number: AS5040 PB
• Description: BOARD PROGRAM AS5040
• Manufacturer: austriamicrosystems

Specifications of AS5040 PB

• Module/board Type: ZIF Socket
• For Use With/related Products: AS5000 Programmer, AS5040
• Lead Free Status / RoHS Status: Lead free by exemption / RoHS compliant by exemption
• Other names: AS5045 PB; AS5140H PB; AS5145 PB

AS5040
Data Sheet
The vertical distance should be chosen such that the magnetic field on the die surface is within the specified limits
(see Figure 20). The typical distance “z” between the magnet and the package surface is 0.5mm to 1.8mm with the
recommended magnet (6mm x 2.5mm). Larger gaps are possible, as long as the required magnetic field strength
stays within the defined limits.
A magnetic field outside the specified range may still produce usable results, but the out-of-range condition will be
indicated by MagINCn (pin 1) and MagDECn (pin 2), see Table 3.
Figure 22: Vertical Placement of the Magnet
16 Simulation Modelling
Figure 23: Arrangement of Hall Sensor Array on Chip (principle)
With reference to Figure 23, a diametrically magnetized permanent magnet is placed above or below the surface of
the AS5040. The chip uses an array of Hall sensors to sample the vertical vector of a magnetic field distributed across
the device package surface. The area of magnetic sensitivity is a circular locus of 1.1mm radius with respect to the
center of the die. The Hall sensors in the area of magnetic sensitivity are grouped and configured such that
orthogonally related components of the magnetic fields are sampled differentially.
orthogonally related cosine vector of the magnetic field.
www.austriamicrosystems.com
The differential signal Y1-Y2 will give a sine vector of the magnetic field. The differential signal X1-X2 will give an
Die surface
N
Package surface
S
Revision 2.10
z
1.282mm ± 0.15mm
0.576mm ± 0.1mm
24 - 33