OM6275,598 NXP Semiconductors, OM6275,598 Datasheet - Page 5

• Manufacturer Part Number: OM6275,598
• Description: DEMO BOARD I2C
• Manufacturer: NXP Semiconductors

Specifications of OM6275,598

• Main Purpose: Interface, I2C Devices, 12
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: PCF8574TS, PCA9536D, PCA9540BD, PCF85116, PCF8563TD, PCA9538D, PCA9551D, SA56004ED, PCA9543AD, PCA9531D, PCA9541D/01, SE98PW
• Primary Attributes: I2C: 2KB EEPROM, (1) 4-Bit & (2) 8-Bit I2C & SMBus I/O, 2Ch Mux, RTC, (2) 8-Bit LED Drivers, (2) Temp Sensors, 2Ch Master
• Secondary Attributes: USB Graphic User Interface
• Other names: 568-3615; 935283054598; OM6275

Philips Semiconductors
4. Hardware description
UM10206
User manual
Fig 2. I2C Demonstration Board 2005-1
USB Port
USB Link Indicator
Figure 2
Remark: Philips recommends connecting only daughter cards developed and provided by
Philips Semiconductors to the extension connector. Philips Semiconductors is not
responsible for damage caused by other target cards.
•
•
•
•
•
USB Port: port where the USB cable is plugged into the board.
USB_LINK LED: this green LED will illuminate when the cable is connected between
the PC and the hardware.
remote sensor diode: where the remote sensor diode is plugged into the board to
allow the SA56004E temperature sensor to monitor the ambient temperature.
microcontroller: a socketed microcontroller is provided to ensure easy service in the
event of damage to the device.
extension connector: this connector is used to connect future daughter cards targeting
specific Philips Semiconductors I
shows the following items on the hardware:
Expansion Connector
Rev. 01 — 13 June 2006
I2C Demonstration Board 2005-1 Quick Start Guide
2
C-bus devices.
Microcontroller
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
Remote Sensor Diode
UM10206
5 of 12