101-0359 Rabbit Semiconductor, 101-0359 Datasheet - Page 41

• Manufacturer Part Number: 101-0359
• Description: KIT DEVELOPMENT BASIC RABBIT2000
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 2000r
• Type: MPU Moduler

Specifications of 101-0359

• Rohs Status: RoHS non-compliant
• Contents: RabbitCore Module, Dev. Board, AC Adapter, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: Rabbit 2000
• Interface Type: RS-232, RS-485
• For Use With/related Products: RCM2000, RCM2010, RCM2020
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 316-1003

4.2.1.4 Analog Input
The analog input channel on the BL1810 (AD0 on header J5) works by varying analog
output channel DA0 until its voltage matches the input voltage on AD0. DA0 obviously
cannot be used while an input voltage is being measured, although channel DA0 is still
available. The value returned corresponds to the value that DA0 required to match the
input voltage (you would call
If the value returned is negative, then the function considers the value suspect for some
reason (most likely a failure of the DA0 voltage to settle quickly). The value can be taken
as is, or another measurement can be done.
An integer between 0 and 1024 will be returned in
obtained if output channel DA0 was set to that value. If a value is found, but the voltage
has not appeared to fully settle, the value will be negative (but equal in magnitude to the
found voltage) to allow remeasurement if desired.
Two versions of the analog input function are available: the standard function, listed
above, that does not return until the measurement has been made, and a cofunction version
that can be called from within a costatement. This cofunction version allows other tasks to
be performed while the voltage match is being made. The voltage measurement will take
ten calls of the cofunction version to make a measurement.
Getting Started Manual
void anaIn(int channel, int *value);
void cof_anaIn(int channel, int *value);
Analog input for the BL1810 analog input channel (AD0).
The parameters are identical to those described above for
jrioInit
channel
NOTE: See sample program JRIOTEST.C for an example of the use of anaIn.
NOTE: See sample program JRIO_COF.C for an example of the use of cof_anaIn.
is the input channel number (0 only on the BL1810).
must be called first.
m
b
anaOut(0,value)
=
=
voltage
-------------------------------------------------------------------- -
PWM_MAX0 PWM_MIN
V
max
–
=
V
m PWM_MAX0
max
m value
×
×
–
–
V
for DA0 to provide that same voltage).
value
anaIn
min
+
b
, corresponding to a voltage
.
37