101-1017 Rabbit Semiconductor, 101-1017 Datasheet - Page 18

• Manufacturer Part Number: 101-1017
• Description: KIT DEV POWERCORE 3800 INT'L
• Manufacturer: Rabbit Semiconductor
• Series: PowerCore FLEXr
• Type: MPU Moduler

Specifications of 101-1017

• Contents: RabbitCore Module, Dev. Board, AC Adapter, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: PowerCore 38xx
• Interface Type: Ethernet
• For Use With/related Products: RCM3800
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

2.2 Hardware Connections
There are three steps to connecting the PowerCore Prototyping Board for use with
Dynamic C and the sample programs:
1. Attach the PowerCore module to the Prototyping Board.
2. Connect the programming cable between the PowerCore module and the workstation PC.
3. Connect the power supply to the PowerCore module.
2.2.1 Attach Module to Prototyping Board
Turn the PowerCore module so that the notched corner is on the top left as shown in
Figure 2 below. Snap in at least one standoff as shown below and then insert the module’s
J4 header into the PC1 socket on the Prototyping Board. The notched corner at the top left
corner of the PowerCore module should face the same direction as the corresponding
notch outline below it on the Prototyping Board
Press the standoff into its corresponding hole and press the module’s pins firmly into the
Prototyping Board socket.
10
NOTE: It is important that you line up the pins on header J4 of the PowerCore module
exactly with the corresponding pins of the PC1 socket on the Prototyping Board. The
header pins may become bent or damaged if the pin alignment is offset, and the module
will not work. Permanent electrical damage to the module may also result if a mis-
aligned module is powered up.
Figure 2. Install the PowerCore Module on the Prototyping Board
PowerCore FLEX