ST62E2XC-EPB/110 STMicroelectronics, ST62E2XC-EPB/110 Datasheet - Page 18

• Manufacturer Part Number: ST62E2XC-EPB/110
• Description: BOARD PROGRAMMING FOR ST625X/6X
• Manufacturer: STMicroelectronics
• Type: MCUr

Specifications of ST62E2XC-EPB/110

• Contents: Programmer Board
• For Use With/related Products: ST7265x
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

EPB - Stand-Alone Mode
5 STAND-ALONE MODE
5.1 METHOD OF OPERATION
Only EPROM programmers equipped with a serial interface can operate in stand-alone mode.
They are:
EPBs enable you to perform several distinct operations on your microcontroller. Depending on
your needs, you may blank check, verify, or program your microcontroller. For this, when op-
erating in stand-alone mode, proceed as follows:
1 Select the stand-alone mode for your EPB,
2 Configure your EPB,
3 Proceed to the desired operation: blank checking, programming, or verifying.
5.2 SELECTING THE STAND-ALONE MODE
To select the stand-alone mode, place (or remove) a jumper at the appropriate location in the
jumper bank of your EPB.
Note: EPBs are shipped with the REMOTE jumper on.
The operation to be performed depends on the type of your EPB:
For more information on EPB general layout, see “Appendix B” on page 34.
18/39
ROM
RAM
UNLOCK
LOCK
OTP
EPROM
DEVICE
TYPE
REMOTE
LOCAL
ST62E2XC,
ST62E4X,
ST62E6X,
and ST63E1XX EPBs.
W1
15
ST62EXX EPB
This jumper on
For ST62EXX EPBs, set the LOCAL jumper in the
W1 jumper bank.