MC56F8006DEMO Freescale Semiconductor, MC56F8006DEMO Datasheet - Page 6

• Manufacturer Part Number: MC56F8006DEMO
• Description: DEMO BOARD FOR MC56F8006
• Manufacturer: Freescale Semiconductor
• Type: DSPr

Specifications of MC56F8006DEMO

• Contents: Board
• Processor To Be Evaluated: MC56F8006
• Interface Type: RS-232, USB
• Operating Supply Voltage: 3.3 V
• Silicon Manufacturer: Freescale
• Core Architecture: 56800/E
• Core Sub-architecture: 56800/E
• Silicon Core Number: MC56F
• Silicon Family Name: MC56F80xx
• Rohs Compliant: Yes
• For Use With/related Products: MC56F8006
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Overview
6
•
•
•
•
•
— Double-buffered PWM registers
— Separate deadtime insertions for rising and falling edges
— Separate top and bottom pulse-width correction by means of software
— Asymmetric PWM output within both Center Aligned and Edge Aligned operation
— Separate top and bottom polarity control
— Each complementary PWM signal pair allows selection of a PWM supply source from:
Two independent 12-bit analog-to-digital converters (ADCs)
— 2 x 14 channel external inputs plus seven internal inputs
— Support simultaneous and software triggering conversions
— ADC conversions can be synchronized by PWM and PDB modules
— Sampling rate up to 400 KSPS for 10- or 12-bit conversion result; 470 KSPS for 8-bit conversion result
— Two 16-word result registers
Two programmable gain amplifier (PGAs)
— Each PGA is designed to amplify and convert differential signals to a single-ended value fed to one of the ADC
— 1X, 2X, 4X, 8X, 16X, or 32X gain
— Software and hardware triggers are available
— Integrated sample/hold circuit
— Includes additional calibration features:
Three analog comparators (CMPs)
— Selectable input source includes external pins, internal DACs
— Programmable output polarity
— Output can drive timer input, PWM fault input, PWM source, external pin output, and trigger ADCs
— Output falling and rising edge detection able to generate interrupts
One dual channel 16-bit multi-purpose timer module (TMR)
— Two independent 16-bit counter/timers with cascading capability
— Up to 96 MHz operating clock
— Each timer has capture and compare and quadrature decoder capability
— Up to 12 operating modes
— Four external inputs and two external outputs
One serial communication interface (SCI) with LIN slave functionality
— Up to 96 MHz operating clock
— Full-duplex or single-wire operation
— Programmable 8- or 9- bit data format
— Two receiver wakeup methods:
— 1/16 bit-time noise detection
– PWM generator
– Internal timers
– Analog comparator outputs
inputs
– Offset calibration eliminates any errors in the internal reference used to generate the VDDA/2 output center
– Gain calibration can be used to verify the gain of the overall datapath
– Both features require software correction of the ADC result
– Idle line
– Address mark
point
MC56F8006/MC56F8002 Digital Signal Controller, Rev. 3
Freescale Semiconductor