STICE-SYS001 STMicroelectronics, STICE-SYS001 Datasheet - Page 7

• Manufacturer Part Number: STICE-SYS001
• Description: EMULATOR FOR STM8
• Manufacturer: STMicroelectronics
• Series: STM8r
• Type: In-Circuit Debugger, Emulator, Programmerr

Specifications of STICE-SYS001

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: STM8
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 497-10029

UM0406
1.2
1.3
STice in in-circuit debugging/programming configuration
In the in-circuit debugging/programming configuration, STice allows you to program your
application to your microcontroller and debug the application while it runs on the MCU on
your application board. Using STice, you can in-circuit program and debug a wide range of
microcontrollers. It supports the single wire interface module (SWIM) protocol for STM8.
In both the emulation and the in-circuit programming/debugging configuration, STice is
driven by the ST Visual Develop (STVD) integrated development environment running on
your host PC, which provides total control of advanced application building, debugging and
programming features from a single easy-to-use interface.
To use STice in ICD/ICP configuration, you need to buy the AD-ICD/ICP adapter kit (see
Table 3 on page
Figure 2.
About the user manuals
This manual helps you set up your emulator and connect it to your PC. It contains:
●
●
For information about other hardware and the software intended for use with your emulator,
refer to the following documents:
●
●
●
●
Quick setup instructions for the emulation and the in-circuit programming/debugging
configurations
A detailed description of product features
STice Connection Accessories User Guide – for instructions regarding the connection
accessories for connecting your emulator to your application board
ST Visual Develop (STVD) on-line help – building and debugging your application
ST Visual Programmer (STVP) on-line help – programming your application to your
microcontroller
Microcontroller Datasheet – for microcontroller specific information
In-circuit programming and debugging configuration
9).
Doc ID 13332 Rev 3
1
1. ICD/ICP flat cable connects STice to MCU
via ICD/ICP connector on application board.
2
2. AD/Stice_Connect: ICD/ICP
connector relayed to MCU (SWIM
protocol for STM8)
3
3. ST microcontroller on
application board
Introduction
7/26