ST62GP-EMU2 STMicroelectronics, ST62GP-EMU2 Datasheet - Page 16

• Manufacturer Part Number: ST62GP-EMU2
• Description: KIT EMULATOR FOR ST6 MCU SER
• Manufacturer: STMicroelectronics
• Series: ST6-EMU2r
• Type: Microcontrollerr

Specifications of ST62GP-EMU2

• Contents: Emulator, Set of Probes, Power Supply, Parallel Cable, and ST6-RIDE Software
• For Use With/related Products: ST62x
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2 - Getting Started
2.3.4
16/57
Probe
3
4
Step 4: Powering up
1
2
3
4
5
6
Slide the dedication board gently back in its slot in the ST62GP-EMU2, pressing
it firmly into place.
Clip the two ferrites to the flat cables, positioning them as close as possible to
each end of the flat cables (see
Plug the power jack from the power adapter to the power connector on the
ST62GP-EMU2 back panel (refer to
Connect the power adapter to the mains power supply.
Plug the probe connector in the MCU socket of the application board.
Power on the PC.
Switch on the ST62GP-EMU2 using the power switch on the back panel (see
Figure 2
The power LED on the front panel should light up (see
Troubleshooting
J2 Connector
).
J1 Connector
Figure 7: Installing the Flat Cables
on page 47, otherwise proceed to the next step.
PIN 1 edges
of flat cables
Ferrites
Figure 7
Figure 2
).
J1 Connector
J1 Connector
ST62GP-EMU2 Emulator User Manual
on page 11).
Figure 4
Dedication
Board
J2 Connector
). If not, refer to