ST62GP-EMU2 STMicroelectronics, ST62GP-EMU2 Datasheet - Page 43

• Manufacturer Part Number: ST62GP-EMU2
• Description: KIT EMULATOR FOR ST6 MCU SER
• Manufacturer: STMicroelectronics
• Series: ST6-EMU2r
• Type: Microcontrollerr

Specifications of ST62GP-EMU2

• Contents: Emulator, Set of Probes, Power Supply, Parallel Cable, and ST6-RIDE Software
• For Use With/related Products: ST62x
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST62GP-EMU2 Emulator User Manual
5.9
OUT1
OUT2
Using the trigger outputs
Two connectors for trigger output signals are available on the front panel of the
ST62GP-EMU2.
You can generate these signals using the Hardware Events/Trigger Menu in the
WGDB6 Debugger. Output OUT1 and OUT2 can be programmed in two ways:
•
•
The SPI data register operates at full speed even in Step mode. For example, if
you load the Data register in Step mode, the value will be output immediately
on the pin.
Synchronization mode (see
synchronization pulses (Trig1 and Trig2) for triggering external hardware. The
events can be defined by addresses or address ranges.
Timing measurement mode (see
elapsed during a subroutine for example, using an oscilloscope connected to
OUT1. In this case, output OUT2 is SET on a user-defined address (Trig1), and
RESET on another one (Trig2).
Trigger Event: Trig1
Figure 19: Synchronization Mode
Trigger Event: Trig2
Figure 19
Figure 20
) allows you to configure two
) allows you to measure the time
5 - Emulator Features
43/57