M3062PT3-CPE Renesas Electronics America, M3062PT3-CPE Datasheet - Page 104

• Manufacturer Part Number: M3062PT3-CPE
• Description: DEV COMPACT EMULATOR M16C/26A,28
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M3062PT3-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M16C/62P
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M3062PT3-CPE User’s Manual
(3) Errors Occur at Emulator Debugger Startup
Table 5.3 Checkpoints of errors at debugger startup
REJ10J1007-0400 Rev.4.00 July 29, 2009
Target MCU is in the reset state.
Target MCU cannot be reset.
Target is in "HOLD" state.
Target clock is stopped.
Target MCU is not receiving power.
Target MCU is uncontrollable.
Error
(1) Check that the reset pin of the user system is pulled up.
(2) Check that the reset pin of the user system has changed from Low to
(1) Check that pin NMI# is held High.
(2) In memory expansion mode or microprocessor mode, check pins
(3) If the reset circuit of the user system has a watchdog timer, disable
(4) Check that power is properly supplied to the user system and that
(1) In memory expansion mode or microprocessor mode, check pins
(2) The MCU is either in stop mode or wait mode. Either reset the MCU
When the clock is supplied from an external oscillator, check that the
oscillator circuit in the user system is oscillating properly.
Check that power is properly supplied to the user system and that the
user system is properly grounded.
(1) Check that the NQPACK etc. mounted on the user system is
(2) Check that the connector is installed properly to the user system.
(3) In memory expansion mode or microprocessor mode, check pins
RDY# and HOLD# at “H” level.
or cancel the mode with an interrupt.
See MCU specifications.
High level.
RDY# and HOLD# are at “H” level.
the timer.
the user system is properly grounded.
soldered properly.
RDY# and HOLD# are at “H” level.
Checkpoint
5. Troubleshooting
Page 102 of 108