M3062PT3-CPE Renesas Electronics America, M3062PT3-CPE Datasheet - Page 97

• Manufacturer Part Number: M3062PT3-CPE
• Description: DEV COMPACT EMULATOR M16C/26A,28
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M3062PT3-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M16C/62P
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M3062PT3-CPE User’s Manual
REJ10J1007-0400 Rev.4.00 July 29, 2009
Note on Clock Supply to the MCU:
Note on Stop and Wait Modes:
Note on Display of MCU Status:
Note on Breaks:
A clock supplied to the evaluation MCU is selected by the Emulator tab in the Init dialog box of the emulator
debugger.
Do not single step an instruction shifting to stop or wait mode. It may cause communications errors.
"MCU status" you can refer to in the MCU tab of the MCU Setting dialog box of the emulator debugger shows
pin levels of the user system. Make sure that proper pin levels are specified according to the mode you use.
The area displaying break points in the program window of the emulator debugger shows the following breaks.
(1) When "Internal" is selected:
(2) When "External" is selected:
(1) Address-match break
(2) Software break
(3) Hardware break
(1) When single-chip mode is used:
(2) When memory expansion mode 16-bit data bus width is used:
(3) When memory expansion mode 8-bit data bus width is used:
(4) When microprocessor mode 16-bit data bus width is used:
(5) When microprocessor mode 8-bit data bus width is used:
CNVss: Low
CNVss: Low, BYTE: Low, HOLD#: High, RDY#: High
CNVss: Low, BYTE: High, HOLD#: High, RDY#: High
CNVss: High, BYTE: Low, HOLD#: High, RDY#: High
CNVss: High, BYTE: High, HOLD#: High, RDY#: High
A clock generated by the oscillator circuit board in the emulator is supplied. It is continually supplied
regardless of the status of the user system clock and that of the user program execution.
A clock generated by the oscillator in the user system is supplied. It depends on the status of the oscillation
(on/off) of the user system.
This is a debugging function which breaks a program, using the address-match interrupt function of the
MCU, immediately before the system executes an instruction at a specified address. The instruction at the
preset address will not be executed.
This is a debugging function which generates a BRK interruption by changing an instruction at a specified
address to a BRK instruction (00h) to break a program immediately before the system executes an
instruction at a specified address. The instruction at the preset address will not be executed.
This is a debugging function which breaks a program by setting the detection of an execution of an
instruction at a specified address as a break event. The program will break after the instruction at the
specified address is executed.
IMPORTANT
4. Hardware Specifications
Page 95 of 108