M3062PT3-CPE-2 Renesas Electronics America, M3062PT3-CPE-2 Datasheet - Page 28

• Manufacturer Part Number: M3062PT3-CPE-2
• Description: EMULATOR COMPACT M16C/26A,28,29
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M3062PT3-CPE-2

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M16C/26A, M16C/28, M16C/29
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M3062PT3-CPE User’s Manual
2.6 Turning ON the Power
2.6.1 MCU Power Supply Source Selection Jumper/MCU Power Supply Voltage Selection Jumper
Set the MCU power supply source selection jumper and the MCU power supply voltage selection jumper of the emulator
according to conditions of use.
Figure 2.6 Jumper switch locations
These are the jumper switches to select power supply to the MCU and its power voltage. As shown in Table 2.2 below, set the
switch according to the connection to the user system.
Table 2.2 Setting jumper switches
REJ10J1007-0400 Rev.4.00 July 29, 2009
Note on Jumper Switch Settings:
the user system
Not connected
Connection to
Connected
P5 P4 P3
512
Always shut OFF the emulator before changing the setting of the jumper switches. Otherwise the internal circuit
may cause a break.
POWER
LED1
POWER
CLOCK
RESET
SAFE
RUN
LED3
LED6
LED2
MCU power supply
source selection
jumper (JP1)
COMPACT EMULATOR
POWER
SAFE
POWER
CLOCK
RESET
RUN
EXT
INT
STATUS
SYSTEM
TARGET
STATUS
COMPACT EMULATOR
M3062PT3-CPE
MADE IN JAPAN
MCU power supply
voltage selection
MADE
jumper (JP2)
Invalid
3.3 V
5.0 V
CAUTION
POWER USB
5.0V
EXT
JP1
JP2
5.0V
3.3V
INT
Supplied from the emulator. The MCU operating
voltage is 3.3 V.
Supplied from the emulator. The MCU operating
voltage is 5.0 V.
Supplied from the user system. This emulator
consumes max. 500mA of electrical current from the
user system.
JP1 : MCU power supply source
(factory-setting : INT)
JP2 : MCU power supply voltage
(factory-setting : 5.0V)
Description
selection jumper
selection jumper
Page 26 of 108
2. Setup