M3062PT3-CPE-2 Renesas Electronics America, M3062PT3-CPE-2 Datasheet - Page 30

• Manufacturer Part Number: M3062PT3-CPE-2
• Description: EMULATOR COMPACT M16C/26A,28,29
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M3062PT3-CPE-2

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M16C/26A, M16C/28, M16C/29
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M3062PT3-CPE User’s Manual
2.6.3 Checking Connections of the Emulator System
Before turning the power ON, check the connection of the interface cable to the host machine, emulator, and user system.
2.6.4 Turning ON/OFF the Power
Turn ON/OFF the power of the emulator and user system as simultaneously as possible.
Do not leave either the emulator or user system powered on, because of leakage current the internal circuits may be damaged.
When turning ON the power again after shutting OFF the power, wait for about 10 seconds.
REJ10J1007-0400 Rev.4.00 July 29, 2009
Notes on Power Supply:
The emulator's pin VCC is connected to the user system in order to monitor user system voltage. For this
reason, the emulator cannot supply power to the user system. Therefore, provide the user system with a separate
power supply from that of the emulator.
This emulator consumes max. 500mA of electrical current from the user system. Please consider the capacity of
the power supply of the user system.
The voltage of the user system should be as follows.
Do not change user system power supply voltage after power has been activated.
(1) When VCC1, VCC2 power selection jumper (JP1 of the M3062PT2-EPBM) is set as VCC1 = 2:
(2) When VCC1, VCC2 power selection jumper (JP1 of the M3062PT2-EPBM) is set as VCC1 > 2:
2.7 V ≤ VCC1 = VCC2 ≤ 5.5 V
VCC1 = 5.0 ± 0.2V
2.7 V ≤ VCC2 < VCC1
IMPORTANT
Page 28 of 108
2. Setup