M3062PT3-CPE-2 Renesas Electronics America, M3062PT3-CPE-2 Datasheet - Page 34

• Manufacturer Part Number: M3062PT3-CPE-2
• Description: EMULATOR COMPACT M16C/26A,28,29
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M3062PT3-CPE-2

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M16C/26A, M16C/28, M16C/29
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M3062PT3-CPE User’s Manual
2.7.2 If an Error is Detected in the Self-check
Table 2.5 lists how to remedy the troubles if the target status LED display is abnormal in the self-check. When an error is
detected, shut off the emulator and the user system and follow the steps in the Table 2.5.
Table 2.5 Error display in the self-check and how to remedy it
REJ10J1007-0400 Rev.4.00 July 29, 2009
Notes on the Self-check:
POWER
CLOCK
LED display
Blinking
Be sure to disconnect the user system before executing the self-check.
Use the preinstalled oscillator circuit board OSC-3 (16MHz) to execute the self-check.
If the self-check does not result normally (excluding target status errors), the emulator may be damaged. Then,
contact your local distributor.
Others
RESET
OFF
RUN
The emulation memory board R0E33062PMSRC0 (not included) is not working
properly.
- The emulation memory board may be damaged. Contact your local distributor.
The emulator system is not working properly.
- Check that power is supplied to the emulator.
- The emulator may be damaged. Contact your local distributor.
A clock is not supplied to the emulator.
- Check that the oscillator circuit board (OSC-3) is attached.
The power is not supplied to the emulator.
- Check that the power supply cable is connected properly.
- Check of jumper switch settings (see Table 2.2).
The vector areas (DBC interrupt vector, single-step interrupt vector and BRK interrupt
vector) which are used by the emulator may be rewritten when debugging in CPU rewrite
mode.
- Start the emulator debugger and execute the program (single-step execution can be
The emulator system is not working properly.
- The emulator may be damaged. Contact your local distributor.
used) to reset the vector areas which are used by the emulator. Then, execute the self-
check.
IMPORTANT
Problem & Remedy
Page 32 of 108
2. Setup