M3062PT3-CPE-4 Renesas Electronics America, M3062PT3-CPE-4 Datasheet - Page 101

• Manufacturer Part Number: M3062PT3-CPE-4
• Description: DEV COMPACT EMULATOR M16C/26A,28
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M3062PT3-CPE-4

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M16C/62P
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M3062PT3-CPE User’s Manual
REJ10J1007-0400 Rev.4.00 July 29, 2009
Notes on Power Supply to the User System:
Notes on CE Declaration of Conformity:
* Electrostatic Discharge Precautions must be taken when handling the product.
* Must not be used within 30 meters of a domestic radio or television receiver.
* For correct operation of this product, it is recommended that Mobile phones are not used within 10 meters of
* This product should be powered down when not in use.
* Use the power supply which complies with CE marking requirements.
Pins VCC1 and VCC2 are connected to the user system to observe the voltage. Therefore, the power is not
supplied to the user system from the emulator, design your system so that the user system is powered separately.
The voltage of the user system should be as follows.
Do not change the voltage of the user system after turning on the power.
Please use this product with care as described below.
This product generates, uses, and can radiate radio frequency energy and may cause harmful interference to
radio communications.
If this product causes harmful interference to radio or television reception, which can be determined by turning
this product off or on, you are encouraged to try to correct the interference by one or more of the following
methods;
* Ensure attached cables do not lie across the probe board and converter board.
* Reorient the receiving antenna.
* Increase the distance between the product and the receiver.
* Connect the product into an outlet on a circuit different from that to which the receiver is connected.
* Consult the dealer or experienced radio/TV technician for help.
Attach the ferrite core included with this product close to the DC plug of the power cable. Without the ferrite
core it may cause interference.
The power cable should be wound around the ferrite core as shown in the figure, and close the ferrite core until
it clicks.
(1) When VCC1, VCC2 power selection jumper (JP1 of the M3062PT2-EPBM) is set as VCC1 = 2:
(2) When VCC1, VCC2 power selection jumper (JP1 of the M3062PT2-EPBM) is set as VCC1 > 2:
this product system.
2.7V ≤ VCC1 = VCC2 ≤ 5.5V
VCC1 = 5.0 ± 0.2V,
2.7V ≤ VCC2 < VCC1
IMPORTANT
4. Hardware Specifications
Page 99 of 108