R0E436640CPE00 Renesas Electronics America, R0E436640CPE00 Datasheet - Page 32

• Manufacturer Part Number: R0E436640CPE00
• Description: EMULATOR COMPACT H8/3664
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of R0E436640CPE00

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: H8/3664
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

R0E436640CPE00 User’s Manual
2.7.2 If an Error is Detected in the Self-check
Table 2.4 lists how to remedy the troubles if the target status LED display is abnormal in the self-check. When an error is
detected, shut off the emulator and the user system and follow the steps in the Table 2.4.
Table 2.4 Error display in the self-check and how to remedy it
REJ10J0918-0300 Rev.3.00 February 15, 2007
Notes on the Self-check:
POWER
CLOCK
LED display
Blinking
Be sure to disconnect the user system before executing the self-check.
Use the preinstalled oscillator circuit board OSC-3 (20 MHz) to execute the self-check.
If the self-check does not result normally (excluding target status errors), the emulator may be damaged. Then,
contact your local distributor.
RESET
OFF
RUN
The emulator system is not working properly.
The emulator system is not working properly.
- Check that power is supplied to the emulator.
- The emulator may be damaged. Contact your local distributor.
A clock is not supplied to the emulator.
- Check that the oscillator circuit board (OSC-3) is attached.
The power is not supplied to the emulator.
- Check that the power supply cable is connected properly.
- Check of jumper switch settings (see Table 2.3).
- The emulator may be damaged. Contact your local distributor.
IMPORTANT
Problem & Remedy
Page 30 of 102
2. Setup