R0E436640CPE00 Renesas Electronics America, R0E436640CPE00 Datasheet - Page 68

• Manufacturer Part Number: R0E436640CPE00
• Description: EMULATOR COMPACT H8/3664
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of R0E436640CPE00

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: H8/3664
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

R0E436640CPE00 User’s Manual
REJ10J0918-0300 Rev.3.00 February 15, 2007
Note on exception handling:
Note on the I/O registers:
Note on Clock Supply to the MCU:
Notes on Software Breaks:
- Low-voltage-detection Status Register (LVDSR: H’F731)
- Reset Source Decision Register (LVDRF: H’F732)
- Clock Control/Status Register (CKCSR: H’F734)
- RC Control Register (RCCR: H’F735)
- RC Trimming Data Protect Register (RCTRMDPR: H’F736)
- RC Trimming Data Register (RCTRMDR: H’F737)
- Flash Memory Control Register 1 (FLMCR1: H’FF90)
- Flash Memory Control Register 2 (FLMCR2: H’FF91)
- Flash Memory Power Control Register (FLPWCR: H’FF92)
- Block Specification Register 1 (EBR1: H’FF93)
- Flash Memory Enable Register (FENR: H’FF9B)
For details, refer to notes on each MCUs in “Notes on Using This Product (2)” (page 75).
In addition, the low-voltage detection interrupt that an evaluation MCU does not have and the exception
handling related to an on-chip oscillator are not supported.
- Low-voltage-detection Control Register (LVDCR: H’F730)
Because the compact emulator emulates several target MCUs with a single evaluation MCU, the exception
handling factors of the actual MCU and those of the evaluation MCU are not always the same. Use only
exception handling factors which the hardware manual describes that it is available.
Since the compact emulator emulates several target MCUs using a single evaluation MCU, the I/O registers of
the actual MCU and those of the evaluation MCU are not always the same. Therefore, do not access the
reserved I/O registers of the target MCU. Note also that accesses to the registers listed below that are associated
with power-on reset & low-voltage detection circuit functions, on-chip oscillator and flash memory control are
invalid.
A clock supplied to the evaluation MCU is selected by the Clock tab in the Init dialog box of the emulator
debugger.
Software breaks change the instruction at a specified address to a BRK (H’5770). Therefore, take note that
when you reference the result of a trace in bus mode, " H’5770" is displayed.
As the BRK instruction is used for the emulator, do not use it in a user program.
(1) When "Internal" is selected:
(2) When "External" is selected:
A clock generated by the oscillation circuit in the emulator is supplied to the evaluation MCU. The clock is
continually supplied to the evaluation MCU regardless of a status of user system clock and a status of user
program execution.
Clock supply to the evaluation MCU depends on oscillation state (oscillate/off) of the user system.
IMPORTANT
4 Hardware Specifications
Page 66 of 102