HDJD-JD05 Avago Technologies US Inc., HDJD-JD05 Datasheet - Page 15

• Manufacturer Part Number: HDJD-JD05
• Description: KIT DEV RGB COLOR SENSOR 20-QFN
• Manufacturer: Avago Technologies US Inc.

Specifications of HDJD-JD05

• Sensor Type: Light, Color Sensor
• Sensing Range: RGB
• Interface: 2-Wire Serial
• Voltage - Supply: 2.5 V ~ 3.6 V
• Embedded: No
• Utilized Ic / Part: ADJD-S313-QR999
• For Use With/related Products: ADJD-S313-QR999
• Lead Free Status / RoHS Status: Not applicable / Not applicable

Recommendations for Handling and Storage of
ADJD-S313
Before Opening the MBB (Moisture Barrier Bag)
• The sensor component must be kept sealed in a
• It should also be seal with a moisture absorbent
Package Tape and Reel Dimensions
Carrier Tape Dimensions
15
SECTION B-B
NOTES:
1. A o AND B o MEASURED AT 0.3 mm ABOVE BASE OF POCKET.
2. 10 PITCHES CUMULATIVE TOLERANCE IS 0.2 mm.
3. DIMENSIONS ARE IN MILLIMETERS (mm).
MBB (Moisture Barrier Bag) stored at 30°C and
70%RH or less at all times.
material (Silica Gel) and an indicator card (Cobalt
Chloride) to indicate the moisture within the bag.
K o
0.30 0.05
B o
B
A
B
SEE NOTE #2
SEE NOTE #2
SECTION A-A
4.00 0.10
2.00 0.05
A o
A
8.00 0.10
R 0.50 TYP.
1.55 0.05
After Opening the MBB (Moisture Barrier Bag)
• The sensor component must be kept at 30°C and
• The sensor component should have a MET
• If unused sensor component remain, it is
• If the indicator card has turned from blue to pink or
• Baking Treatment: 24 hours at 125°C.
60%RH or less
(Manufacturing Exposure Time) of 24 hours starting
from the time of removal from the MBB to the
soldering oven.
recommended to store them back to the MBB.
it has exceeded the recommended MET
(Manufacturing Exposure Time) of 24hrs, baking
treatment should be performed using the following
conditions before continue to IR reflow soldering.
A o :
B o :
K o :
PITCH:
WIDTH:
1.75 0.10
1.50 (MIN.)
5.50 0.05
12.00
5.30
5.30
2.20
8.00
12.00 0.10