ST92F150-EMU2 STMicroelectronics, ST92F150-EMU2 Datasheet - Page 19

• Manufacturer Part Number: ST92F150-EMU2
• Description: BOARD EMULATOR FOR ST9 SERIES
• Manufacturer: STMicroelectronics
• Series: ST9-EMU2r
• Type: Microcontrollerr

Specifications of ST92F150-EMU2

• Contents: ST9 Visual Debug IDE, ST9 HDS2V2 Mainboard, Probe, Sockets, Adapters, Power Supply,Cables & Documentation
• For Use With/related Products: ST9 MCUs
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 497-3101

ST92F150-EMU2 User Manual
3
3.1
3.2
external TTL clock source
CONFIGURING THE EMULATOR
Selecting the clock source for the ST9+ chip
You can select one of the three clock sources for ST92F150 emulation chip:
•
•
•
The clock source selection is done thanks to five solder points (G3, G4, G5, G6,
G7) and one jumper W4. On the following table “N” means no contact, “Y” means
the solder points contacts must be soldered together.
on probe 4 MHz oscillator
As delivered, the emulator clock source selected is the on-probe 4 MHz oscillator.
The two contact points of both the G3 and G5 solder points are connected with a
thin copper wire, and the W4 jumper is in the P-OSC position.
To remove the connection on the G3 and G5 solder points, simply scratch the thin
copper wire between the two contacts of each solder point.
Selecting the A/D converter analog reference source AV
You can supply AV
application using AV
on probe quartz (4 MHz)
A quartz (not provided), to be located on the probe between C4 and C5.
A 4 MHz oscillator (provided), located on probe at location OSC2.
The target TTL clock source, located on your application board.
Clock Source
(XT1)
Table 1: Clock source solder points and jumper settings
AV
DD
from application (AVDD pin)
Table 2: AV
AV
DD
DD
DD
from emulator probe
pin of ST92F150.
either from emulator probe power supply or from your
DD
G3
N
Y
Y
supply selection solder points
G4
N
N
Y
G5
N
Y
Y
G1
N
Y
3 - Configuring the Emulator
G6
Y
N
N
DD
G2
G7
N
Y
N
N
N
P-OSC
T-OSC
W4
x
19/55