ST92F150-EMU2 STMicroelectronics, ST92F150-EMU2 Datasheet - Page 27

• Manufacturer Part Number: ST92F150-EMU2
• Description: BOARD EMULATOR FOR ST9 SERIES
• Manufacturer: STMicroelectronics
• Series: ST9-EMU2r
• Type: Microcontrollerr

Specifications of ST92F150-EMU2

• Contents: ST9 Visual Debug IDE, ST9 HDS2V2 Mainboard, Probe, Sockets, Adapters, Power Supply,Cables & Documentation
• For Use With/related Products: ST9 MCUs
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 497-3101

ST92F150-EMU2 User Manual
3.10
3.11
Analyser probe
The analyser probe, a SUBD9 connector located on the front panel of the emulator
main board casing, provides eight external probe inputs that can be used as:
•
•
They are synchronized with DSn and respect the 5 V TTL input levels: V
V
The analyser probe cable consists of 8 colored wires that correspond to specific
pin numbers, as shown below in
Configuring the timestamp clock
The Timestamp clock can be configured using ST9+ Visual Debug. Open the
Trace window by selecting, from the main menu, View>Trace . With your cursor in
the Trace window, right-click to obtain the Trace contextual menu, and then select
Emulator Commands>Set Timestamp Clock . The Timestamp Clock dialog box,
shown in
The clock source available for timestamp clock depends upon the ST92F150 clock
source selected (see
•
•
IH
possible advanced breakpoint events
bus signals in the trace.
When using the on-probe quartz, only use the fixed 20 MHz reference is
available for use as the timestamp clock. No configuration is required—the
timestamp clock is set by default to Internal.
When using the on-probe oscillator or the external TTL clock source from
= 2 V.
Figure 12
Table 6: Pin/wire color correspondence on analyser probe
on page 28, will appear.
Input Number
Section 3.1
0
1
2
3
4
5
6
7
Table 6
on page 19):
.
Wire Color
Orange
Brown
Yellow
Green
Violet
Grey
Blue
Red
3 - Configuring the Emulator
IL
= 0.8 V,
27/55