DV007004 Microchip Technology, DV007004 Datasheet - Page 115
![PROGRAMMER UNIVERSAL PM3](/photos/9/33/93302/dv007004_sml.jpg)
DV007004
Manufacturer Part Number
DV007004
Description
PROGRAMMER UNIVERSAL PM3
Manufacturer
Microchip Technology
Series
MPLAB® PM3r
Type
Universalr
Specifications of DV007004
Contents
MPLAB PM3 Programming Unit, Cables, Power Supply and IDE
Positions/sockets
1
Ic Product Type
Programmer, Universal
Supported Families
PICmicro, DsPIC30F
Kit Contents
LCD, ICSP Support, 40-pin Socket, Digital/Multimedia Card Slot
Rohs Compliant
NA
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
Microchip's PICmicro devices including dsPIC30F
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
For Use With
PICmicro And DsPIC30F DSC Devices
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
DV007004
Manufacturer:
Microchip Technology
Quantity:
135
Company:
Part Number:
DV007004
Manufacturer:
MICROCHIP
Quantity:
12 000
Company:
Part Number:
DV007004 (MPLAB PM3)
Manufacturer:
MICROCHIP
Quantity:
12 000
© 2006 Microchip Technology Inc.
5. Make sure that a COM port is properly set up exclusively for use by MPLAB PM3.
6. Some system errors are caused by driver and hardware incompatibility.
7. You must use the Microsoft Windows communications driver that is native to the
8. Make sure you are not using a third party communications driver. Open your
B.4.2
If you have been using another programmer (e.g., PICSTART Plus), the MPLAB PM3
menu might not be available. Select Programmer>Select Programmer to open the
Select Programmer dialog and choose MPLAB PM3 from the list. After you select the
programmer, MPLAB IDE will issue you a warning prompt and shut itself down.
MPLAB IDE must be restarted before the programmer options are available. The
MPLAB PM3 menu will appear on the menu bar when MPLAB IDE is restarted.
B.4.3
MPLAB PM3 uses COM1 as the default serial port the first time you run MPLAB PM3.
If you change your serial port selection with the Programmer>Communications Port
Setup command, then the next time you run MPLAB PM3, the host software will use
the same serial port used in the previous session.
B.4.4
If the device you selected when setting up the development mode in MPLAB IDE is not
supported by the MPLAB PM3 Operating System, a message box will appear when you
try to enable the programmer.
Make sure you allow MPLAB PM3 to upgrade to get the latest versions for MPLAB IDE
software and MPLAB PM3 operating system (Section 7.8 “Upgrading the MPLAB
PM3 Operating System”).
Check the resources to ensure they are operating properly and that there are no
conflicts with other devices. This commonly happens when you have a modem
or other serial device that is improperly configured. Consult your Windows man-
ual or other reference literature. You can try removing, reconfiguring or disabling
the conflicting device, but do so only if you are familiar with those procedures.
version of Windows that you use.
SYSTEM.INI file and look for the line in the [OPTIONS] section that reads
COMM.DRV=COMM.DRV
If this line reads differently, you are using a different communications driver.
No MPLAB PM3 Menu Visible
Default Serial Port
Operating System Update Needed
DS51464C-page 109