DV007004 Microchip Technology, DV007004 Datasheet - Page 67

• Manufacturer Part Number: DV007004
• Description: PROGRAMMER UNIVERSAL PM3
• Manufacturer: Microchip Technology
• Series: MPLAB&reg PM3r
• Type: Universalr

Specifications of DV007004

• Contents: MPLAB PM3 Programming Unit, Cables, Power Supply and IDE
• Positions/sockets: 1
• Ic Product Type: Programmer, Universal
• Supported Families: PICmicro, DsPIC30F
• Kit Contents: LCD, ICSP Support, 40-pin Socket, Digital/Multimedia Card Slot
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: Microchip's PICmicro devices including dsPIC30F
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: PICmicro And DsPIC30F DSC Devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

© 2006 Microchip Technology Inc.
If the EPROM device is not blank, erase it before programming, or select another
device:
1. Remove any labels covering the device window. A non-windowed device cannot
2. Place the device in an Ultraviolet (UV) EPROM Eraser. The amount of time
3. Before attempting to program the device, perform the Blank Check again to verify
7.4.8
With the device inserted the socket, select Programmer>Erase Flash Device from the
MPLAB PM3 menu. Then, select Programmer>Blank Check All from the MPLAB PM3
menu. This check will verify that the device is completely blank (all bits are set to
and all Configuration bits are set to the default value.
7.4.9
To reset all the program statistics, select Programmer>Reset Program Statistics. This
command will reset the counters in the Program Statistics area.
7.4.10
To transfer the hex file to the programmer, select Programmer>Transfer to MPLAB
PM3. This command only transfers the data, it does not program the device. This is
usually used for stand-alone operation.
7.4.11
To transfer the programmer memory to the hex file, select Programmer>Transfer from
MPLAB PM3. This command only transfers the programmer memory, it does not read
the device memory. This is especially useful for reading the programmer memory back
after working in Stand-Alone mode.
7.4.12
To establish communications between the PC and MPLAB PM3 after power has been
disconnected from the programmer, select Programmer>Establish Communications.
This command resets the programmer hardware and reestablishes communications. It
does not reset programming information in the Program Memory window, Configuration
bits or IDs.
7.4.13
Select Programmer>About to display version of the MPLAB PM3 OS Suite in the
programmer.
Note:
be reprogrammed. A windowed version of all EPROM devices may be ordered
by requesting the JW package.
required to completely erase a UV erasable device depends on: the wavelength
of the light, its intensity, distance from UV source and the process technology of
the device (how small the memory cells are).
that it is blank.
Erase Flash Device
Reset Program Statistics
Transfer to MPLAB PM3
Transfer from MPLAB PM3
Establish Communications
About
If the device is EEPROM or Flash, it is not necessary to erase it before
reprogramming it. These devices are electrically erased before
programming.
DS51464C-page 61
‘1’
)