S202SE2 Sharp Microelectronics, S202SE2 Datasheet - Page 9
![no-image](/images/manufacturer_photos/0/6/603/sharp_microelectronics_sml.jpg)
S202SE2
Manufacturer Part Number
S202SE2
Description
RELAY SSR 240VAC 8A ZC 4-SIP
Manufacturer
Sharp Microelectronics
Series
S202r
Datasheet
1.S202SE2.pdf
(14 pages)
Specifications of S202SE2
Circuit
SPST-NO (1 Form A)
Output Type
AC, Zero Cross
Load Current
8A
Voltage - Input
1.2VDC
Voltage - Load
0 ~ 240 V
Mounting Type
Through Hole
Termination Style
PC Pin
Package / Case
4-SIP
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
On-state Resistance
-
Other names
425-1251-5
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
S202SE2
Manufacturer:
SHARP
Quantity:
20 000
(a) Make sure there are no warps or bumps on the heat sink, insulation sheet and device surface.
(b) Make sure there are no metal dusts or burrs attached onto the heat sink, insulation sheet and device
(c) Make sure silicone grease is evenly spread out on the heat sink, insulation sheet and device surface.
Silicone grease to be used is as follows;
1) There is no aged deterioration within the operating temperature ranges.
2) Base oil of grease is hardly separated and is hardly permeated in the device.
3) Even if base oil is separated and permeated in the device, it should not degrade the function of a device.
Recommended grease : G-746 (Shin-Etsu Chemical Co., Ltd.)
In case the optional heat sink is screwed up, please solder after screwed.
In case of the lead frame bending, please keep the following minimum distance and avoid any mechanical
stress between the base of terminals and the molding resin.
Some of AC electromagnetic counters or solenoids have built-in rectifier such as the diode.
In this case, please use the device carefully since the load current waveform becomes similar with
rectangular waveform and this results may not make a device turn off.
Example how to equip optional heat sink for reinforced isolation
2) Case of the use of double isolation sheet (V
Please keep 5mm distance as minimum between naked metal portion of SSR and heat sink, and also
between naked metal portion of SSR and bis/nut/washer.
However, please avoid the natural rubber for isolation sheet.
1) Case of isolation sheet whose thickness is 0.4mm or more (V
surface.
: G-747 (Shin-Etsu Chemical Co., Ltd.)
: SC102 (Dow Corning Toray Silicone Co., Ltd.)
0.4mm thickness or more
isolation sheet
Isolation sheet
SSR
SSR
iso
: each 3kV or more)
9
4.4mm MIN.
Heat sink
Heat sink
iso
: 3kV or more)
S202SE2 Series
Sheet No.: D4-A03301EN