Z8F012AQB020EG Zilog, Z8F012AQB020EG Datasheet - Page 38

• Manufacturer Part Number: Z8F012AQB020EG
• Description: IC ENCORE XP MCU FLASH 1K 8-QFN
• Manufacturer: Zilog
• Series: Encore!® XP®r

Specifications of Z8F012AQB020EG

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: IrDA, UART/USART
• Peripherals: Brown-out Detect/Reset, LED, LVD, POR, PWM, Temp Sensor, WDT
• Number Of I /o: 6
• Program Memory Size: 1KB (1K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 16 x 8
• Ram Size: 256 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 105°C
• Package / Case: 8-VQFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-3759

PS022825-0908
Internal RESET
System Clock
Note: Not to Scale
VCC = 3.3 V
signal
Watchdog Timer Reset
External Reset Input
V
V
POR
VBO
The POR level is greater than the VBO level by the specified hysteresis value. This
ensures that the device undergoes a Power-On Reset after recovering from a VBO
condition.
If the device is in NORMAL or HALT mode, the Watchdog Timer can initiate a System
Reset at time-out if the WDT_RES Flash Option Bit is programmed to 1. This is the
unprogrammed state of the WDT_RES Flash Option Bit. If the bit is programmed to 0, it
configures the Watchdog Timer to cause an interrupt, not a System Reset, at time-out.
The WDT bit in the Reset Status (RSTSTAT) register is set to signify that the reset was
initiated by the Watchdog Timer.
The RESET pin has a Schmitt-Triggered input and an internal pull-up resistor. Once the
RESET pin is asserted for a minimum of four system clock cycles, the device progresses
through the System Reset sequence. Because of the possible asynchronicity of the system
clock and reset signals, the required reset duration may be as short as three clock periods
Execution
Program
Figure 6. Voltage Brownout Reset Operation
Brownout
Voltage
Reset, Stop Mode Recovery, and Low Voltage Detection
counter delay
POR
Z8 Encore! XP
Product Specification
Execution
Program
®
F082A Series
VCC = 3.3 V
27