Z8F0812SJ020EC Zilog, Z8F0812SJ020EC Datasheet - Page 87

• Manufacturer Part Number: Z8F0812SJ020EC
• Description: IC ENCORE MCU FLASH 8K 28SOIC
• Manufacturer: Zilog
• Series: Encore!® XP®r

Specifications of Z8F0812SJ020EC

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: I²C, IrDA, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 19
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 105°C
• Package / Case: 28-SOIC (7.5mm Width)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Data Converters: -
• Other names: 269-3228

PS022517-0508
3. Write to the PWM High and Low Byte registers to set the PWM value.
4. Write to the Timer Reload High and Low Byte Registers to set the Reload value
5. If required, enable the timer interrupt and set the timer interrupt priority by writing to
6. Configure the associated GPIO port pin for the Timer Output alternate function.
7. Write to the Timer Control Register to enable the timer and initiate counting.
The PWM period is given by the following equation.
If an initial starting value other than
Registers, the ONE-SHOT mode equation is used to determine the first PWM time-out
period.
If
If
CAPTURE Mode
In CAPTURE mode, the current timer count value is recorded when the desired external
Timer Input transition occurs. The Capture count value is written to the Timer PWM High
and Low Byte Registers. The timer input is the system clock. The
Control Register determines if the Capture occurs on a rising edge or a falling edge of the
Timer Input signal. When the Capture event occurs, an interrupt is generated and the timer
continues counting.
The timer continues counting up to the 16-bit Reload value stored in the Timer Reload
High and Low Byte registers. Upon reaching the Reload value, the timer generates an
interrupt and continues counting.
Follow the steps below for configuring a timer for CAPTURE mode and initiating the
count:
1. Write to the Timer Control Register to:
PWM Period (s)
PWM Output High Time Ratio (%)
PWM Output High Time Ratio (%)
TPOL
TPOL
(PWM period). The Reload value must be greater than the PWM value.
the relevant interrupt registers.
–
Disable the timer
is set to 0, the ratio of the PWM output High time to the total period is given by
is set to 1, the ratio of the PWM output High time to the total period is given by
=
------------------------------------------------------------------------------ -
System Clock Frequency (Hz)
Reload Value
=
=
0001H
x
----------------------------------- - x100
Reload Value
Prescale
Reload Value PWM Value
------------------------------------------------------------------------ -x100
PWM Value
is loaded into the Timer High and Low Byte
Reload Value
–
Z8 Encore! XP
Product Specification
TPOL
bit in the Timer
®
F0822 Series
Timers
74