ZGP323HSP2004G Zilog, ZGP323HSP2004G Datasheet - Page 33

• Manufacturer Part Number: ZGP323HSP2004G
• Description: IC Z8 GP MCU 4K OTP 20DIP
• Manufacturer: Zilog
• Series: Z8® GP™r

Specifications of ZGP323HSP2004G

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 8MHz
• Peripherals: HLVD, POR, WDT
• Number Of I /o: 16
• Program Memory Size: 4KB (4K x 8)
• Program Memory Type: OTP
• Ram Size: 237 x 8
• Voltage - Supply (vcc/vdd): 2 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 20-DIP (0.300", 7.62mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -
• Connectivity: -
• Other names: 269-4384; ZGP323HSP2004G

Table 7. CTR0(D)00H Counter/Timer8 Control Register (Continued)
PS023807-0707
Field
Counter_INT_Mask
P34_Out
Note:
*
*
Indicates the value upon Power-On Reset.
*Indicates the value upon Power-On Reset. Not reset with a Stop Mode Recovery.
Note:
Caution:
T8 Enable
This field enables T8 when set (written) to 1.
Single/Modulo-N
When set to 0 (Modulo-N), the counter reloads the initial value when the terminal count is
reached. When set to 1 (single-pass), the counter stops when the terminal count is reached.
Timeout
This bit is set when T8 times out (terminal count reached). To reset this bit, write 1 to its
location.
Take care when using the OR or AND commands to manipulate CTR0, bit 5 and CTR1,
bits 0 and 1 (DEMODULATION Mode). These instructions use a Read-Modify-Write
sequence in which the current status from the CTR0 and CTR1 registers is ORed or
ANDed with the designated value and then written back into the registers.
T8 Clock
This bit defines the frequency of the input signal to T8.
Capture_INT_Mask
Set this bit to allow an interrupt when data is captured into either LO8 or HI8 on a
positive or negative edge detection in DEMODULATION mode.
Writing 1 is the only way to reset the Terminal Count status condition. Reset this bit
before using/enabling the counter/timers.
The first clock of T8 might not have complete clock width and can occur any time when
enabled.
Bit Position
------1-
-------0
R/W
R/W
1
1
Value
0**
0*
Description
Disable Time-Out Interrupt
Enable Time-Out Interrupt
P34 as Port Output
T8 Output on P34
Product Specification
Functional Description
ZGP323H
28