MC68HC908LJ12CFU Freescale Semiconductor, MC68HC908LJ12CFU Datasheet - Page 215

• Manufacturer Part Number: MC68HC908LJ12CFU
• Description: IC MCU 12K FLASH 8MHZ 64-QFP
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC68HC908LJ12CFU

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: IRSCI, SPI
• Peripherals: LCD, LVD, POR, PWM
• Number Of I /o: 32
• Program Memory Size: 12KB (12K x 8)
• Program Memory Type: FLASH
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 6x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

12.4.5 Chronograph Functions
12.5 Low-Power Modes
12.5.1 Wait Mode
12.5.2 Stop Mode
MC68HC908LJ12
Freescale Semiconductor
—
Rev. 2.1
A 100Hz resolution chronograph counter can be enabled by setting the
CHRE bit. The chronograph counter will automatically roll over to zero
when the counter reaches 99. If 32.768kHz CGMXCLK is used, the
chronograph counter resolution becomes 128Hz. With either 100Hz or
128Hz resolution, the counter value is converted to 100Hz, before it is
saved in the chronograph data register. Therefore, each chronograph
data register increment represents 10ms.
The STOP and WAIT instructions put the MCU in low power-
consumption standby modes.
The RTC module continues normal operation in wait mode. Any enabled
CPU interrupt request from the RTC can bring the MCU out of wait
mode. If the RTC is not required to bring the MCU out of wait mode,
power down the RTC by clearing the RTCE bit before executing the
WAIT instruction.
For continuous RTC operation in stop mode, the oscillator stop mode
enable bit (STOP_XCLKEN in CONFIG2 register) must be set before
executing the STOP instruction. When STOP_XCLKEN is set,
CGMXCLK continues to drive the RTC module, and any enabled CPU
interrupt request from the RTC can bring the MCU out of stop mode.
If STOP_XCLKEN bit is cleared, the RTC module is inactive after the
execution of a STOP instruction. The STOP instruction does not affect
RTC register states. RTC module operation resumes after an external
interrupt. To further reduce power consumption, the RTC module should
be powered-down by clearing the RTCE bit before executing the STOP
instruction.
Real Time Clock (RTC)
Real Time Clock (RTC)
Technical Data
215