LMC6032IMX/NOPB National Semiconductor, LMC6032IMX/NOPB Datasheet - Page 10

• Manufacturer Part Number: LMC6032IMX/NOPB
• Description: IC OP AMP DUAL CMOS 8-SOIC
• Manufacturer: National Semiconductor

Specifications of LMC6032IMX/NOPB

• Amplifier Type: General Purpose
• Number Of Circuits: 2
• Slew Rate: 1.1 V/µs
• Gain Bandwidth Product: 1.4MHz
• Current - Input Bias: 0.04pA
• Voltage - Input Offset: 1000µV
• Current - Supply: 750µA
• Current - Output / Channel: 40mA
• Voltage - Supply, Single/dual (±): 4.75 V ~ 15.5 V, ±2.38 V ~ 7.75 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Number Of Channels: 2
• Voltage Gain Db: 126.02 dB
• Common Mode Rejection Ratio (min): 60 dB
• Input Voltage Range (max): 15.5 V
• Input Voltage Range (min): 4.75 V
• Input Offset Voltage: 9 mV
• Operating Supply Voltage: 5 V, 9 V, 12 V, 15 V
• Supply Current: 0.38 mA
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Maximum Dual Supply Voltage: +/- 7.75 V
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Output Type: -
• -3db Bandwidth: -
• Lead Free Status / Rohs Status: Details
• Other names: *LMC6032IMX/NOPB

www.national.com
Application Hints
The designer should be aware that when it is inappropriate
to lay out a PC board for the sake of just a few circuits, there
is another technique which is even better than a guard ring
on a PC board: Don’t insert the amplifier’s input pin into the
board at all, but bend it up in the air and use only air as an
insulator. Air is an excellent insulator. In this case you may
have to forego some of the advantages of PC board con-
struction, but the advantages are sometimes well worth the
effort
See Figure 7.
of
FIGURE 6. Guard Ring Connections
using
(d) Howland Current Pump
(b) Non-Inverting Amplifier
(a) Inverting Amplifier
point-to-point
(c) Follower
(Continued)
up-in-the-air
01113507
01113509
01113510
01113508
wiring.
10
(Input pins are lifted out of PC board and soldered directly to components.
All other pins connected to PC board.)
BIAS CURRENT TESTING
The test method of Figure 8 is appropriate for bench-testing
bias current with reasonable accuracy. To understand its
operation, first close switch S2 momentarily. When S2 is
opened, then
A suitable capacitor for C2 would be a 5 pF or 10 pF silver
mica, NPO ceramic, or air-dielectric. When determining the
magnitude of I
must be taken into account. Switch S2 should be left shorted
most of the time, or else the dielectric absorption of the
capacitor C2 could cause errors.
Similarly, if S1 is shorted momentarily (while leaving S2
shorted)
where C
FIGURE 8. Simple Input Bias Current Test Circuit
x
is the stray capacitance at the + input.
b
−, the leakage of the capacitor and socket
FIGURE 7. Air Wiring
01113512
01113511