WM8351GEB/V Wolfson Microelectronics, WM8351GEB/V Datasheet - Page 197

• Manufacturer Part Number: WM8351GEB/V
• Description: Audio CODECs Audio CODEC plus pwr management
• Manufacturer: Wolfson Microelectronics

Specifications of WM8351GEB/V

• Number Of Adc Inputs: 2
• Number Of Dac Outputs: 2
• Conversion Rate: 48 KSPS
• Interface Type: Serial (2-Wire, 3-Wire, 4-Wire)
• Resolution: 12 bit
• Operating Supply Voltage: 3.7 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: BGA
• Minimum Operating Temperature: - 25 C
• Number Of Channels: 2 ADC/2 DAC
• Supply Current: 260 uA
• Thd Plus Noise: - 83 dB
• Audio Codec Type: Stereo
• No. Of Adcs: 2
• No. Of Dacs: 2
• No. Of Input Channels: 8
• No. Of Output Channels: 6
• Adc / Dac Resolution: 24bit
• Adcs / Dacs Signal To Noise Ratio: 95dB
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Production Data
w
R26 (1Ah)
Interrupt Status
2
R34 (22h)
Interrupt Status
2 Mask
Table 139 Watchdog Timer Interrupts
Note that, if GPIO9 is configured as VCC_FAULT output (GP9_FN = 0001, GP9_DIR = 0), then the
Watchdog Timer will be configured to expect a HEARTBEAT reset trigger. In this configuration, the
Watchdog Reset will never occur and the system may lock up if the Watchdog Mode is enabled.
The Watchdog Timer function cannot be supported if GPIO9 is configured as VCC_FAULT output.
Either the GPIO9 must be reconfigured as some other function, or the Watchdog Timer must remain
disabled.
Note that Config Mode 01 selects GPIO9 = VCC_FAULT by default.
ADDRESS
BIT
0
0
SYS_WDOG_TO_EINT
IM_SYS_WDOG_TO_EINT
LABEL
Watchdog timeout has occurred.
(Rising Edge triggered)
Note: This bit is cleared once read.
Mask bit for Watchdog timer interrupt
When set to 1, IM_SYS_WDOG_TO_EINT
masks SYS_WDOG_TO_EINT in R26 and
does not trigger an SYS_INT interrupt when
SYS_WDOG_TO_EINT is set).
DESCRIPTION
PD, March 2010, Rev 4.2
WM8351
197