PKG.M0.8SL.VJ LEMO, PKG.M0.8SL.VJ Datasheet - Page 69

• Manufacturer Part Number: PKG.M0.8SL.VJ
• Description: Circular Push Pull Connectors 8P FML RECP R/A PCB GRAY FRONT NUT
• Manufacturer: LEMO
• Series: 1P Seriesr

Specifications of PKG.M0.8SL.VJ

• Product Type: Connectors
• Contact Style: Socket (Female)
• Shell Style: Receptacle
• Number Of Contacts: 8
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Crimp LV contacts
1
2
Crimp
L
3
T
Solder
4
5
7
For PSU only:
We recommend ONLY the use of VTCS-6 Clear Vibra-tite or
ThreeBond 1401 to secure the connector backnut. The use of
other materials could result in damage to the connector.
The only recommended chemical cleaner is Isopropyl Alcohol.
1.Strip the cable according to the lengths given in the table.
2.Slide the retaining nut ➀, the washer ➁, the seal ➂ and the
3.Fix the appropriate positioner (table page 51) in the
4.Now arrange contact-conductor combinations according
5.Slide the clamping sleeve ➃ forward and locate tag ➄
6.Push the whole assembly into the shell ➈ whilst turning it
6
Tin the conductors. In case of a screened cable separate
the braid and twist it apart as shown.
clamping sleeve ➃.
In case of a screened cable solder the braid into the
earthing contact ➅.
crimping tool. Set selector to the number corresponding
to the conductor AWG as indicated on the positioner
label. Fit conductor into contact ➆ and make sure it is
visible through the inspection hole in the crimp barrel.
Slide conductor-contact combination into the open
crimping tool; make sure that the contact is fully pushed
into the positioner. Close the tool. Remove from crimping
tool and check that conductor is secure in contact and
shows in inspection hole.
to the insert marking and locate them into the insert ➄.
Check that all contacts are correctly located and remain
in position when given a gentle pull. In case of a
screened cable introduce the earthing contact ➅ into the
insert ➇. Check that contact is correctly located and
remains in position when given a gentle pull.
into one of the insulator slot according to the selected
polarization code. Make sure that same code is used for
plug and socket.
Tight the screw of the clamping sleeve ➃ to secure the
cable. Slide washer and seal against clamping sleeve.
to insure that the tag ➄ is correctly located in the inside
slot of the shell. Tighten the retaining nut ➀ to the
maximum torque of 1.2 Nm.
– Socket mounting nut or screws = 2.3 Nm.
306, 310, 314
Configuration
8
19.0
Dimensions (mm)
L
9
5.4
T
67