S29GL01GP12FFI020 Spansion Inc., S29GL01GP12FFI020 Datasheet - Page 49

• Manufacturer Part Number: S29GL01GP12FFI020
• Description: IC, FLASH, 1000MBIT, 120NS, TSOP-64
• Manufacturer: Spansion Inc.

Specifications of S29GL01GP12FFI020

• Memory Type: Flash
• Memory Size: 1000Mbit
• Memory Configuration: 128K X 16
• Ic Interface Type: Parallel
• Access Time: 120ns
• Supply Voltage Range: 2.7V To 3.6V
• Memory Case Style: TSOP
• No. Of Pins: 64
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

9. Power Conservation Modes
9.1
9.2
9.3
9.4
November 28, 2007 S29GL-P_00_A8
8.6.3
8.6.4
Standby Mode
Automatic Sleep Mode
Hardware RESET# Input Operation
Output Disable (OE#)
Write Pulse “Glitch Protection”
Power-Up Write Inhibit
Noise pulses of less than 5 ns (typical) on OE#, CE# or WE# do not initiate a write cycle.
If WE# = CE# = RESET# = V
rising edge of WE#. The internal state machine is automatically reset to the read mode on power-up.
When the system is not reading or writing to the device, it can place the device in the standby mode. In this
mode, current consumption is greatly reduced, and the outputs are placed in the high impedance state,
independent of the OE# input. The device enters the CMOS standby mode when the CE# and RESET#
inputs are both held at V
is ready to read data. If the device is deselected during erasure or programming, the device draws active
current until the operation is completed. I
specification
The automatic sleep mode minimizes Flash device energy consumption. The device automatically enables
this mode when addresses remain stable for t
CE#, WE#, and OE# control signals. Standard address access timings provide new data when addresses are
changed. While in sleep mode, output data is latched and always available to the system. I
represents the automatic sleep mode current specification.
The RESET# input provides a hardware method of resetting the device to reading array data. When RESET#
is driven low for at least a period of t
all outputs, and ignores all read/write commands for the duration of the RESET# pulse. The device also
resets the internal state machine to reading array data. The operation that was interrupted should be
reinitiated once the device is ready to accept another command sequence to ensure data integrity.
When RESET# is held at V
not within V
RESET# may be tied to the system reset circuitry and thus, a system reset would also reset the Flash
memory, enabling the system to read the boot-up firmware from the Flash memory.
When the OE# input is at V
impedance state. (With the exception of RY/BY#.)
SS
D a t a
± 0.3 V, the standby current is greater.
S h e e t
CC
SS
IH
± 0.3 V. The device requires standard access time (t
IL
, output from the device is disabled. The outputs are placed in the high
S29GL-P MirrorBit
± 0.3 V, the device draws I
and OE# = V
( P r e l i m i n a r y )
RP
, the device immediately terminates any operation in progress, tristates
CC4
IH
in “DC Characteristics” represents the standby current
ACC
during power up, the device does not accept commands on the
®
Flash Family
+ 30 ns. The automatic sleep mode is independent of the
CC
reset current (I
CC5
). If RESET# is held at V
CE
) for read access, before it
CC6
in
Section 11.6
IL
but
49