SAK-C505CA-4EMCA Infineon Technologies, SAK-C505CA-4EMCA Datasheet - Page 51

• Manufacturer Part Number: SAK-C505CA-4EMCA
• Description: IC, 8BIT MCU, 32K OTP, SMD
• Manufacturer: Infineon Technologies

Specifications of SAK-C505CA-4EMCA

• Core Size: 8bit
• No. Of I/o's: 34
• Program Memory Size: 32KB
• Ram Memory Size: 256Byte
• Cpu Speed: 20MHz
• Oscillator Type: External, Internal
• No. Of Timers: 3
• No. Of Pwm Channels: 4
• Digital Ic Case Style: MQFP
• Controller Family/series: C500
• Peripherals: ADC
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Oscillator Watchdog
The oscillator watchdog unit serves for three functions:
Data Sheet
– Monitoring of the on-chip oscillator's function
– Fast internal reset after power-on
– Control of external wake-up from software power-down mode
The watchdog supervises the on-chip oscillator's frequency; if it is lower than the frequency
of the auxiliary RC oscillator in the watchdog unit, the internal clock is supplied by the RC
oscillator and the device is brought into reset; if the failure condition disappears (i.e. the on-
chip oscillator has a higher frequency than the RC oscillator), the part, in order to allow the
oscillator to stabilize, executes a final reset phase of typ. 1 ms; then the oscillator watchdog
reset is released and the part starts program execution from address 0000 H again.
The oscillator watchdog unit provides a clock supply for the reset before the on-chip oscillator
has started. The oscillator watchdog unit also works identically to the monitoring function.
When the power-down mode is left by a low level at the P3.2/INT0 pin or the P4.1/RXDC pin,
the oscillator watchdog unit assures that the microcontroller resumes operation (execution of
the power-down wake-up interrupt) with the nominal clock rate. In the power-down mode the
RC oscillator and the on-chip oscillator are stopped. Both oscillators are started again when
power-down mode is released. When the on-chip oscillator has a higher frequency than the
RC oscillator, the microcontroller starts program execution by processing a power down
interrupt after a final delay of typ. 1 ms in order to allow the on-chip oscillator to stabilize.
47
C505/C505C/C505A/C505CA
12.00