HMC1001 Honeywell Microelectronics & Precision Sensors, HMC1001 Datasheet - Page 7

• Manufacturer Part Number: HMC1001
• Description: SENSOR LINEAR MAGN 1 AXIS 8-SIP
• Manufacturer: Honeywell Microelectronics & Precision Sensors
• Type: Linearr

Specifications of HMC1001

• Rohs Status: RoHS non-compliant
• Sensing Range: ±2g
• Voltage - Supply: 5 V ~ 12 V
• Output Type: Differential Voltage
• Features: Compass - One Axis
• Operating Temperature: -55°C ~ 150°C
• Package / Case: 8 Pin SIP
• Current - Supply: -
• Current - Output (max): -
• Other names: 342-1001-5

HMC1001/1002/1021/1022
For simpler circuits with less critical requirements for noise and accuracy, a single polarity pulse circuit may be employed
periodically (all sets or all resets). With these uni-polar pulses, several uni-polar pulses become close in performance to a
single bipolar set/reset pulse circuit.
NOISE CHARACTERISTICS
The noise density curve for a typical AMR sensor is shown in the figure below. The 1/f slope has a nominal corner
frequency near 10Hz and flattens out to a 3.8 nV/sqrtHz slope. This is approximately equivalent to the Johnson noise (or
white noise) for an 850 ohm resistor, the typical bridge resistance. To relate the noise density voltage to the magnetic
fields, use the following expressions:
For Vbridge = 5V and Sensitivity = 3.2mV/V/gauss, the bridge output (Voutput) is 16mV/gauss
The noise density at 1Hz is about 30nV/sqrtHz or 1.8 micro-gauss/sqrtHz
1/f noise (0.1 to 10Hz) = 30 * sqrt[(ln10/0.1)] nV = 64nV (rms) = 4 micro-gauss (rms) = 27 micro-gauss (pk-pk)
White noise (BW = 1kHz) = 3.8 * sqrt[BW] nV = 120nV (rms) = 50 micro-gauss (pk-pk)
www.honeywell.com
7