AS5046-ASST austriamicrosystems, AS5046-ASST Datasheet - Page 35

• Manufacturer Part Number: AS5046-ASST
• Description: IC ENCODER PROG 12-BIT 16-SSOP
• Manufacturer: austriamicrosystems
• Type: Linear, Rotary Encoder - Programmabler

Specifications of AS5046-ASST

• Sensing Range: 45mT ~ 75mT
• Voltage - Supply: 3 V ~ 3.6 V, 4.5 V ~ 5.5 V
• Current - Supply: 21mA
• Current - Output (max): 4mA
• Output Type: Analog, Ratiometric
• Features: Programmable
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 16-SSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: AS5046-ASSTTR

AS5046
Data Sheet
19 Simulation Modelling
Figure 24
With reference to Figure 24, a diametrically magnetized permanent magnet is placed above or below the surface of
the AS5046. The chip uses an array of Hall sensors to sample the vertical vector of a magnetic field distributed across
the device package surface. The area of magnetic sensitivity is a circular locus of 1.1mm radius with respect to the
center of the die. The Hall sensors in the area of magnetic sensitivity are grouped and configured such that
orthogonally related components of the magnetic fields are sampled differentially.
The differential signal Y1-Y2 will give a sine vector of the magnetic field. The differential signal X1-X2 will give an
orthogonally related cosine vector of the magnetic field.
The angular displacement (Θ) of the magnetic source with reference to the Hall sensor array may then be modelled
by:
The ±0.5° angular error assumes a magnet optimally aligned over the center of the die and is a result of gain
mismatch errors of the AS5046. Placement tolerances of the die within the package are ±0.235mm in X and Y
direction, using a reference point of the edge of pin #1 (Figure 24).
In order to neglect the influence of external disturbing magnetic fields, a robust differential sampling and ratiometric
calculation algorithm has been implemented. The differential sampling of the sine and cosine vectors removes any
common mode error due to DC components introduced by the magnetic source itself or external disturbing magnetic
fields. A ratiometric division of the sine and cosine vectors removes the need for an accurate absolute magnitude of
the magnetic field and thus accurate Z-axis alignment of the magnetic source.
The recommended differential input range of the magnetic field strength (B
the die. In addition to this range, an additional offset of ±5mT, caused by unwanted external stray fields is allowed.
The chip will continue to operate, but with degraded output linearity, if the signal field strength is outside the
recommended range. Too strong magnetic fields will introduce errors due to saturation effects in the internal
preamplifiers. Too weak magnetic fields will introduce errors due to noise becoming more dominant.
www.austriamicrosystems.com
Θ
=
Arrangement of Hall Sensor Array on Chip (principle)
arctan
(
(
X
Y
1
1
−
−
Y
X
2
2
)
)
±
+/-0.235mm
0
5 .
2.433mm
°
AS5046 die
sensor array: 1.1mm radius
3.9mm +/-0.235mm
Radius of circular Hall
1
Revision 1.12
X1
Y2
Y1
Center of die
X2
(X1-X2)
,B
(Y1-Y2)
) is ±75mT at the surface of
35 – 42