CV500CN228 Omron, CV500CN228 Datasheet - Page 43

• Manufacturer Part Number: CV500CN228
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500CN228

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

4-1
4-1-1 Before Using the PT
Preparing to Operate the PT
Creating Screen Data
Equipment
Using the PT
Note The PT reads and writes data to allocated bits and words in the PC even if the PC
How to create screen data, Direct Connection, and connecting the Support Tool
are described below before the use of the PT is explained.
This section describes PC program creation and Support Tool screen data cre-
ation only as it relates to using the PT. For details of other procedures, refer to
1-4 System Configuration .
The relationship between PT, PC and Support Tool operations is shown below.
is not set to Run mode.
Control of the PT and reading the status with the Peripheral Tool monitoring
functions are also enabled.
The PT switches the display between multiple screens. All screen data for a
single PT corresponds to a single file.
Screen data can be created by one of the following three methods:
The following equipment and settings are used in the examples in this section:
General memory:
PT:
NT600M-DT211 (EL display, touch panel version NT600M)
PC:
OMRON C200H
Support Tool
Direction Connection
OMRON
Set with the Tool Setting screen on the Support Tool. Refer to 4-1-3 Setting
Direct Connection for details.
NT20M/NT2000M/NT600M Support Tool Version 4.0 &
creating a new file;
editing an existing file;
reading and editing selected screens from an existing file.
The memory area used depends on the PC type. Refer to Appendix B PC
Memory Map for details.
Create programs
Run mode
(see note)
PC
Screen 1
Screen 2
Screen 3
PC
Transfer mode
Run mode
PT
File
Screen 1
Screen 2
Screen 3
Support Tool
Transfer screen data
Create screen data
Support Tool
Section 4-1