PGMMOD00 Red Lion Controls, PGMMOD00 Datasheet - Page 6

• Manufacturer Part Number: PGMMOD00
• Description: Display Programming Module
• Manufacturer: Red Lion Controls

Specifications of PGMMOD00

• Accessory Type: Display Programming Module
• Module Type: Programming/Display
• For Use With: IAMS Universal Signal Conditioning Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PROGRAMMING MODE ENTRY (OK KEY)
programing mode is entered by pressing the OK key. If the password protection
is enabled, entry of the password is required to gain access. If the password
protection is disabled, direct access to programming will occur.
MENU ENTRY (ARROW & OK KEYS)
between the programming modules. Select the desired module, press the OK
key enter the module programming.
PARAMETER SELECTION AND ENTRY (ARROW & OK
KEYS)
to the desired action for a specific appplication. Each parameter has a list of
selections or a numeric value that can be entered. The parameters are displayed
on line #2 and the selection is on line #1. The arrow keys will move through the
selection list or increase or decrease the numeric values. Once the selection or
numeric value is set to the desired action, press the OK key to enter the data and
move to the next parameter.
PROGRAMMING MODE EXIT (ARROW & OK KEYS)
set-up position. At this time additional programming modules can be selected
for programming or the selection of
exit the Programming Mode, save any changes, and enable the Display Mode.
(If power loss occurs before returning to the display mode, verify recent
parameter changes.)
STEP BY STEP PROGRAMMING INSTRUCTIONS:
4.0 R
5.0 P
A programming module, PGMMOD00 is required to program the unit. The
Upon entering the programming mode (set-up), the arrow keys will index
In each of the Programming Modules are parameters that can be configured
After completing a programming module loop, the display will return to the
Note: The unit will return to the Display Mode from any menu after 1
minute without a key press or by pressing and holding the OK key for
2 seconds. In these cases, verify recent parameter changes.
1
2
ROGRAMMING THE
EVIEWING THE
PUSH BUTTONS
DISPLAY
These keys are only active in the programming mode.
“” can be entered. Entering “” will
Line 1
Line 2
Line 3
Line 4
OK
∧
∨
: Total of four lines.
- increases the numerical value or choose the next selection
- Enters programming mode,
- decreases the numerical value or choose the previous selection
saves the chosen value and proceeds to the next selection
PROGRAMMING MENU
: Configuration of the unit is by the use of the three function keys.
Display Mode
Displays input signal
Displays input units
Displays output signal
Displays communication and relay status
F
OVERVIEW
RONT
U
6
NIT
FAST SETPOINT MODE
OK
B
∧
∨
- displays setpoint 1 and increases the shown setpoint value
- saves the changed setpoint value and returns to the Display Mode
- displays setpoint 2 and decreases the shown setpoint value
UTTONS AND
(Holding for 2 seconds returns to the Display Mode without saving.)
Programming Mode
Shows the selected parameter value
Shows the selected parameter
Shows scrolling help text
Shows communication and relay status
FAST SET MENU
Warning: Save all programming
changes before entering
 . Do this by
exiting the Program Mode at
the  prompt and
then reentering.
D
ISPLAY