CS1W-CN313 Omron, CS1W-CN313 Datasheet - Page 126

• Manufacturer Part Number: CS1W-CN313
• Description: "CABLE CS1 EXP I/O,30cm"
• Manufacturer: Omron

Specifications of CS1W-CN313

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

4-2
Ambient Temperature
Maintenance
External Wiring
104
Installation Precautions
Installation Precautions
When installing the CQM1H in a control panel, observe the following points.
The ambient temperature range in which the CQM1H can be used is 0 to
55 C (0 to 45 C if a Programming Console is connected to the CPU Unit).
Use the CQM1H in a well-ventilated area.
Do not mount the CQM1H directly above heaters, transformers, large-capac-
ity resistors, or any other devices that radiate a large amount of heat energy.
If the ambient temperature is higher than 55 C, install a fan or cooler as
shown in the above diagram so that the temperature is maintained at a maxi-
mum of 55 C.
Do not install the CQM1H close to high-voltage or power devices.
Observe the following precautions for external wiring.
• When multi-conductor signal cable is being used, avoid combining I/O
• If wiring racks are parallel, allow at least 300 mm (12 inches) between the
• Run CQM1H power supply lines and power cables (400-V/10-A max. or
wires and other control wires in the same cable.
racks.
220-V/20-A max.) as shown in the following diagram.
general control circuit wiring
PC power supply and
PC I/O wiring
Power lines
Louver
Control panel
Low-current cables
Control cables
Power cables
CQM1H
Fan
Ground to 100
300 mm min.
300 mm min.
or less
Section 4-2