SNAP-PS5 OPTO 22, SNAP-PS5 Datasheet - Page 4

• Manufacturer Part Number: SNAP-PS5
• Description: POWER SUPPLY, SWITCH MODE, 5V
• Manufacturer: OPTO 22
• Type: Power Suppliesr

Specifications of SNAP-PS5

• Power Supply Type: Switching
• Power Supply Output Type: Fixed
• No. Of Outputs: 1
• Output Voltage: 5V
• Output Current: 4A
• Input Voltage: 95V AC To 130V AC
• Length: 102.86mm
• Width: 44.44mm
• Height: 106.69mm
• Configuration: Enclosed
• Current, Output: 4 A
• Dimensions: 4.05 in. L x 4.89 in. H x 1.75 in. W
• Frequency, Operating: 47 to 63 Hz
• Mounting Type: Panel
• Number Of Outputs: 1
• Operation: Linear
• Output: 5 VDC @ 4 A
• Primary Type: AC-DC
• Temperature, Operating: 0 to +70 °C
• Voltage, Input: 120 VAC
• Voltage, Output: 5 VDC
• Weight: 15 Oz.
• Lead Free Status / RoHS Status: na

PAGE
4
Wiring—Primary Power Supply
Wiring to a Standalone Controller
1. For a controller, check the controller’s specifications in its data
2. Follow directions in the controller’s user’s guide to wire the
Wiring to a SNAP I/O Unit
1. Using the power terminals on the SNAP mounting rack, attach
Opto 22 • 43044 Business Park Drive • Temecula, CA 92590-3614 • www.opto22.com
SALES 800-321-6786 • 951-695-3000 • FAX [phone] • [e-mail] • SUPPORT 800-835-6786 • 951-695-3080 • FAX [phone] • [e-mail]
© 2006–2009 Opto 22. All rights reserved. Dimensions and specifications are subject to change. Brand or product names used herein are trademarks or registered trademarks of their respective companies or organizations.
sheet or user’s guide to make sure you have the correct power
supply for the controller’s requirements.
power supply to the controller. The power supply’s red (or
white-and-red) wire is the positive wire; the black (or white-
and-black) wire is the negative wire.
the red wire to the “+” terminal and the black wire to the “-”
terminal.
2. For the SNAP-PS5 (not illustrated): Using the removable
3. For the SNAP-PS5-24DC (not illustrated): Using the
4. For the SNAP-PS5U (illustrated below): Using the remov-
input power connector on top of the power supply, apply 120
volts AC power between the two terminals marked “AC.” The
ground terminal should be connected to ground.
removable input power connector on top of the power supply,
apply 24 volts DC power between the two terminals marked
“±DC.” The ground terminal should be connected to ground.
able input power connector on top of the power supply, apply
100–250 volts AC power between the two terminals marked
“AC.” The ground terminal should be connected to ground.
SNAP Power Supplies