ENW-C9A21A4EF Panasonic - ECG, ENW-C9A21A4EF Datasheet - Page 10

• Manufacturer Part Number: ENW-C9A21A4EF
• Description: RF MODULE 802.15.4 W/ANT SNAP
• Manufacturer: Panasonic - ECG
• Series: PAN4561r

Specifications of ENW-C9A21A4EF

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4
• Applications: General Purpose
• Power - Output: 0dBm
• Sensitivity: -92dBm
• Voltage - Supply: 2.7 V ~ 3.4 V
• Current - Receiving: 45mA
• Current - Transmitting: 43mA
• Data Interface: PCB, Surface Mount
• Memory Size: 60kB Flash, 4kB RAM
• Antenna Connector: On-Board, Chip
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: ENW-C9A21A4EF; ENWC9A21A4EF; P14522TR; PAN4560; PAN4561L; Q5659594

CLASSIFICATION
SUBJECT
CUSTOMER’S CODE
PAN4561H /M /L
PANASONIC ELECTRONIC DEVICES EUROPE GMBH
7.1. SOFTWARE DIFFERENCES
7.1.1.
7.1.2.
7.1.3.
Modules with Test / Demo software are intended for customer writing their own software for
the module. The module contains software but only with a small instruction set.
The front end IC CC2591 / CC2590 is enabled and disabled with RF transceiver GPIO4.
Set high to enable and low to disable the chip. Please refer to appendix [10].
The LNA has two modes, high and low gain. This mode is controlled with RF transceiver
GPIO3. Set it high for high gain and low for low gain mode. Please refer to appendix [10].
The RXTX signal on CC2591 and CC2590 is controlled by CT_Bias pin. Please refer to
appendix [10].
Modules with E-Senza software can be used to set up a measurement system easily with a
GUI.
With this software it is not possible to set the modules into energy saving sleep mode.
With Synapse software the customer writes his own scripts based on easy to learn, Phyton
based, programming language. This software is very flexible and can be used for multiple
applications.
The control of PA/LNA is primary supported from version
The Synapse software on the module provides several initializing parameters called NV-
parameters. These are already set. For detailed information refer to SNAP Reference
Manual [9].
To comply to FCC regulation the power level has to be reduced to txPwr(14) for
PAN4561H. For detailed information on FCC compliance refer to chapter 27. Regulatory
Information.
Synapse Wireless Inc. probably releases two to three times a year a new SNAP release.
PAN4561 modules will always be shipped with the
Test / Demo software
E-Senza software
Synapse software
MODEM FOR 802.15.4 IEEE STANDARD
PRODUCT SPECIFICATION
PANASONIC PART NUMBER
ENWC9A22xxEF / .25xx. / .21xx.
newest SNAP
SNAPv2.2.15 or
No.
DS-4561-2400-102
PAGE
DATE
www.pedeu.pansonic.de
version.
newer.
06.08.2010
10 of 34
REV.
G