CRD42L51 Cirrus Logic Inc, CRD42L51 Datasheet - Page 31

• Manufacturer Part Number: CRD42L51
• Description: Ref Bd Low-voltage Stereo Codec
• Manufacturer: Cirrus Logic Inc

DS679F1
4.3.5
4.3.6
Analog Input Multiplexer
A stereo 4-to-1 analog input multiplexer selects between a line-level input source, or a mic-level input
source, depending on the PDN_PGAx and AINx_MUX[1:0] bit settings. Signals may be routed to or by-
passed around the PGA. To conserve power, the PGA’s may be powered down allowing the user to select
from multiple line-level sources and route the stereo signal directly to the ADC. When using the MIC pre-
amp, however, the PGA must be powered up.
Analog input channel B may also be used as an output for the MIC bias voltage. The MICBIAS_SEL bit
routes the bias voltage to either of two pins. The multiplexer must then select from the remainder of the
two input channels.
The ADC, PGA and MIC pre-amplifier each has an associated input resistance. When selecting between
these paths, the input resistance to the CODEC will change accordingly. Refer to the input resistance
characteristics in the
MIC & PGA Gain
The MIC-level input passes through a +16 dB or +32 dB analog gain stage prior to the input multiplexer,
allowing it to be used for microphone level signals without the need for any external gain. The PGA must
be powered up when using the MIC pre-amp.
The PGA stage provides an additional +12 dB to -3 dB of analog gain in 0.5 dB steps.
Software
Controls:
Software
Controls:
“Power Control 1 (Address 02h)” on page
Input Select, Invert & Mute (Address 07h)” on page
“Power Control 1 (Address 02h)” on page
page
page
56,
59,
Characteristic and Specification Tables
“ALCX & PGAX Control: ALCA, PGAA (Address 0Ah) & ALCB, PGAB (Address 0Bh)” on
“MIC Control (Address 05h)” on page
49,
49,
“ADCx Input Select, Invert & Mute (Address 07h)” on
“MIC Control (Address 05h)” on page 53 “ADCx
53.
for the input resistance of each path.
56.
CS42L51
31